Panasonic DMP-BDT105 Network Easy Setting, When you experience problems with settings

Network Easy Setting

After completing “Easy Setting”, you can continuously perform “Network Easy Setting”.

1 Select “Wired” or “Wireless” and press [OK].

Network Easy Setting (Connection Check)

Select a connection mode.

Current setting : Wired

LAN cable connection:

Connect a LAN cable to the unit and select "Wired."

Wireless LAN connection:

Connect the Wireless LAN Adaptor (DY-WL10) to the USB port and select "Wireless."

Wired

Wireless

OK

RETURN

If “Wireless LAN Adaptor is not connected.” is displayed, check that the Wireless LAN Adaptor is fully inserted. Alternatively, disconnect and reconnect it. If there is still no change in the display, consult your dealer.

2 Follow the on-screen instructions and make the settings with [3, 4, 2, 1] and press [OK].

For wireless LAN connection:

If you are using a Wireless router (Access point) that supports WPS, you can easily perform the settings by selecting “WPS (PUSH button method)”.

Otherwise, perform the settings by selecting “Search for access point” or “Manual setting” in “Other methods”.

Access Point Connection Setting

Select a connection method to use with an access point of Wireless LAN.

Please refer to the operating instructions of the access point about connection methods.

WPS (PUSH button method)

	Other methods
OK	Search for access point
	WPS (PIN code method)
RETURN
	Manual setting

≥WPS (Wi-Fi Protected Setup) is a function that facilitates settings relating to the connection and security of wireless LAN devices. To see whether your Wireless router (Access point) supports WPS, check the Wireless router operating instructions.

When you experience problems with settings

Access Point Connection Setting

Access Point Connection Setting

Failed to connect to the access point.

A conflict with another device occurred.

Do you want to configure Access Point Connection

Setting again ?

Yes	No	Settings&
Display	Check the following
OK
		Connections
A conflict with another	≥ Please wait a few moments,
device occurred.	and then try again.
	≥ Setting of the Wireless router
A time out error	(Access point) for MAC
	Address etc.
occurred.
	≥ The signal may be weak.
	Using the USB extension
	cable supplied with the
	Wireless LAN Adaptor, adjust
	the position of the Wireless
An authentication error	LAN Adaptor.
	≥ The SSID (> 14) and the
or a time out error	encryption key of the Wireless
occurred.
	router (Access point).

≥Please wait a few moments, and then try again.

≥Connection of Wireless LAN

A device error occurred.	Adaptor
	If there is no improvement in
	symptom, contact our
	Customer Service Center.

VQT2U33 13