Panasonic DMP-B500 Turning on/off the unit, Easy Setting, Turn the unit off automatically

∫Detaching the battery pack

Bottom side of this unit

2 Slide.

RELEASE

DETACHATTACH

1Press and hold.

When not using for long periods of time

≥Detach the battery pack (> above).

(Even when the unit is turned off, there is a small amount of voltage running through the unit, and this may result in a malfunction.)

≥Recharge the battery for re-use.

∫Recharging the battery pack

Attach the battery pack and connect the AC adaptor (> 10).

≥The [CHARGE] indicator lights while charging the battery, and the [CHARGE] indicator turns off when battery charging is finished.

[CHARGE] indicator (Orange light)

∫Approximate recharging and play times

(Hours)

			Play*2
Battery pack	Recharging*1	LCD brightness level
		j5	0	i5
DY-DB30	5	3.5	3	2.75
(included/
optional)
DY-DB15	4	2.75	2.5	2.25
(optional)
DY-DB100	7.5	5.5	5	4.5
(optional)

*1 When the unit is off [at 20 oC (68 oF)]

*2 At room temperature using headphones [at 20 oC (68 oF)]

≥Play time indicated above may differ depending on the use.

≥To change the LCD brightness (> 12, “Adjusting the pictures on the LCD screen”).

∫Checking the remaining battery charge

Not displayed when the AC adaptor is in use.

Press [SUB MENU] while the power is “On”

Remaining charge is displayed for a few seconds at the bottom right of the screen.

Fully charged	Recharge
	(flashing)

Charge the battery pack when the display starts to flash.

≥Appears automatically when there is only a few minutes of charge remaining.

Turning on/off the unit

Press [POWER Í] (approx. 0.5 sec.).

The unit is turned off when [POWER Í] is pressed again.	started
≥ When the “Auto Power Off” is set to “On” (initially set to “On”),
the unit will be turned off automatically after 15 minutes	Getting
≥ The startup will take time. The operation related to startup of
(5 minutes when the battery pack is used) when it is in
stopped status (> 40).
the unit after turning on this unit can be quickened by setting
the initial setup “Quick Start” (> 40) to “On”. (The power
consumption will increase)
≥ You may hear operational sounds when the unit is turned on,
but this is due to the initialization of the pickup unit, and it is
not a malfunction.

Easy Setting

After installation of the unit and pressing [POWER Í] for the 1st time, a screen for the basic settings will appear.

Follow the on-screen instructions and make the settings with [3, 4] and [OK].

“On-screen Language” (> 38), “Picture Quality Mode” (> 12), “DST” (> 40), “Clock Adjustment” (> 40) and “Quick Start” (> 40) are set.

≥After completing “Easy Setting”, you can continuously perform “Network Easy Setting” (> 32).

≥You can perform this setup anytime by selecting “Easy Setting” in the Setup menu. (> 40)

≥You can also change this setting individually.

Turn the unit off automatically

The unit is turned off automatically after set time has passed.

Switch by pressing the [OFF TIMER].

e.g., 30 min.

Off Timer 0 : 30

It will switch every time it is pressed.

Off 0:30 1:00 2:00 3:00 6:00 12:00

VQT2J81

(ENG)

11