Network Easy Setting

Press [SETUP].

Precautions of Wireless LAN Adaptor

The following limits are in place regarding the usage of this device. You must be aware of these limits before using this device.

Panasonic will in no way be responsible for any incidental damage which may arise due to a failure to obey these limits, or to any condition of use or disuse of this device.

≥Do not use this device to connect to any wireless network for which you do not have usage rights. During automatic searches in a wireless network environment, wireless networks (SSID*) for which you do not have usage rights may be displayed; however, using these networks may be regarded as illegal access.

*An SSID (Service Set IDentification) is a name used by wireless LAN to identify a particular network. Transmission is possible if the SSID matches for both devices.

≥Data transmitted and received over radio waves may be intercepted and monitored.

≥This wireless LAN adaptor contains delicate electronic components.

Please use this adaptor in the manner in which it was intended and follow the following points:

jDo not expose the adaptor to high temperatures or direct sunlight.

jDo not bend, or subject the adaptor to strong impacts. jKeep the adaptor away from moisture.

jDo not disassemble or alter the adaptor in any way.

jDo not attempt to install the adaptor in any incompatible device.

VQT2J81

(ENG)

Setting for when this unit is used connected to a network.

≥After completing “Easy Setting” (> 11), you can continuously perform “Network Easy Setting”. (B Go to step 4)

Preparation

Connect to a broadband network. (> 31)

2 Press [3, 4] to select “Network” and press [OK].

3 Press [3, 4] to select “Network Easy Setting” and press [OK].

4 Select “Wired” or “Wireless” and press [OK].

Network Easy Setting (Connection Test)

Select a connection mode.

Current setting

: Wired

LAN cable connection:

Connect a LAN cable to the unit and select "Wired."

Wireless LAN connection:

Connect the Wireless LAN Adaptor (DY-WL10) to the USB port and select "Wireless."

Wired

Wireless

RETURN

≥Supplied Wireless LAN Adaptor and DY-WL10 are equivalent to each other.

If “Wireless LAN Adaptor is not connected.” is displayed, check that the Wireless LAN Adaptor is fully inserted. Alternatively, disconnect and reconnect it. If there is still no change in the display, consult your dealer.

5 Follow the on-screen instructions and make the settings with [3, 4, 2, 1] and press [OK].

For wireless LAN connection:

If you are using a Wireless router (Access point) that supports WPS, you can easily perform the settings by selecting “WPS (PUSH button method)”.

Otherwise, perform the settings by selecting “Search for access point” or “Manual setting” in “Other methods”.

Access Point Connection Setting

Select a connection method to use with an access point of Wireless LAN.

Please refer to the operating instructions of the access point about connection methods.

WPS (PUSH button method)

		Other methods
	OK	Search for access point
	OK	WPS (PIN code method)
	RETURN	WPS (PIN code method)
		Manual setting

≥WPS (Wi-Fi Protected Setup) is a function that facilitates settings relating to the connection and security of wireless LAN devices. To see whether your Wireless router (Access point) supports WPS, check the Wireless router operating instructions.