Indicators and screen messages
Indicators
The [CHARGE] indicator flashes rapidly.
¾There is a problem with the battery pack. Turn the unit on and check the message on the LCD. (> below, 45)
¾Update of the firmware did not complete successfully. Perform the update again. (> 34)
The [CHARGE] indicator flashes slowly.
¾Battery pack charge is low. The unit will turn off automatically after a few minutes.
SD card access indicator is flashing
¾This unit is reading from the SD card, or writing to the SD card. Do not remove the SD card from this unit.
Screen messages
Cannot read. Please check the disc.
¾Clean the disc. (> 5)
¾You inserted a disc that has not been finalized. (> 6)
ERROR U580
¾A problem has occurred with the battery pack. Consult your dealer.
ERROR U581
¾The battery pack has been recharging but has failed to recharge for some reason. Recharge again.
F∑∑
H ∑∑
(∑∑ stands for a number.)
¾A problem has occurred. (Numbers following the “F” or the “H” will be different depending on the status of the unit) Turn off the unit once, and turn it back on. Alternatively, turn off the unit, disconnect the AC adaptor and the battery pack, and attach them back again.
Authorization Error.
This unit is not authorized to play this title.
¾[DivX]: You are trying to play the DivX VOD content that was purchased with a different registration code. You cannot play the content on this unit. (> 24)
Cannot play.
¾You inserted an incompatible disc (Discs recorded in PAL video, etc.). (> 6)
Cannot display on this unit.
¾You tried to play a
¾
No disc is inserted.
¾The disc may be upside down.
Rental Expired.
¾[DivX]: The DivX VOD content has zero remaining plays. You cannot play it. (> 24)
$This operation is not available.
¾Some operations are unsupported by the unit. For example;
ERROR U582
¾You are recharging in a location that is too hot or too cold. Recharge at normal temperature [i5 to i35 oC (i41 to i95 oF)].
$This operation is prohibited by this disc.
¾Depending on the disc, you may not be able to perform search or skip when film previews and warning screens are being played back.
U72
U73
¾There was a problem when connecting the HDMI. jConnected device is not compatible with HDMI. jUse a cable with an HDMI logo.
jThe HDMI cable is damaged.
Cannot connect.
Please check the connection of the LAN cable.
¾When a hub is used but its Link lamp does not light up, check the cable connection, LAN terminal connection, cable itself (a crossover cable may have been used by mistake), etc.
(> 31)
U76
¾
U77
¾Video cannot be output since the copyright protection information on the
IP address is not set.
¾The “IP Address” in “IP Address / DNS Settings” is
.
VQT2J81
(ENG)
44