Carbine PLUS 6850 manual Programming the LCD Transmitter

Page 5

Programming the LCD Transmitter

Vibration/Melody Mode

This mode is useful when you are in a noisy place and it is difficult to hear the beep from the transmitter. While in the Vibration/Melody Mode, the transmitter will vibrate if your security system has been activated.

1. Press and hold the and buttons at the same time until one long beep is heard. Programming has now been entered.

2.Within 5 seconds, press the button to select the vibration or Melody Mode. The icon will be displayed on the screen to show the remote transmitter is in

Vibration Mode.

3.To exit the Programming Mode, take no action for five seconds. The remote control will generate two long beeps to indicate Programming Mode has been exited.

Power Save Mode

While in the Power Save Mode, the LCD remote transmitter will “Sleep” until a button is pushed, extending the life of battery. When Power Save Mode is “OFF”, the remote control will wake up periodically to check for messages from the

security system.

 

 

1.

Press and hold the

and

buttons at the same time until one long beep is

 

heard. Programming has now been entered.

2.

Within 5 seconds, press the

button to toggle between “ON” or “OFF”. The

remote will beep once for “ON”, and twice for “OFF”. When Power Save Mode is “ON”, the icon on the LCD screen indicates entry into Power Save Mode.

3.To exit Programming Mode, take no action for five seconds. The remote control will generate two long beeps indicating Programming Mode has been exited.

Screen Lamp On

Press the button once, and the LCD screen lamp will turn on for 5 seconds.

System Status Check

To check the system’s present status through the LCD screen, press the

transmitter button first, then within 3 seconds press and buttons at the same time. The response will be one melody sound, and the LCD screen will be illuminated. Note: If no response is received, then you are out of range.

Clear the Flash Icon and Melody Sound

Press the button first, then within 3 seconds press the and buttons at the same time. These steps will clear the flash icon and melody sound on the LCD transmitter.

Stop the Trigger Melody Sound

While triggering the alarm the LCD screen will alert the user through a melody sound and a flashing trigger icon. Press any button on the LCD transmitter to stop melody sound only, and the remote control will not send a command to the system.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents User’s Manual Contents LCD Remote Icons Remote Control TransmittersSystem Function Remark LCD Remote Control Transmitter OperationTwo Steps Door Unlock PressProgramming the LCD Transmitter LED Indicator Battery ReplacementInterference System FunctionParking Lights Chirp IndicatorsSystem Characteristics Automatic Arming Manual Arming Lock & ArmDisarming without a Transmitter Manual Disarming Unlock & DisarmCar Locator Exit Valet ModePanic Function PositionAnti-Car Jacking Trigger the Anti-Car Jacking ModeActive Anti-Car Jacking Passive Anti-Car JackingPower-On Memory Timer Control Output ChannelDome Light Supervision Ignition Controlled Door LocksRemote Start Your Vehicle Using the Remote Transmitter Temporary Stop FeaturePress the button twice on the transmitter Engine will start in approximately 5 secondsTimer Start Turbo Timer ModeExit Timer Start To ActivateShut Down Input for Remote Starter Disabling The Remote Start System If InstalledTurn Off Remote Start Return to First Car Operation For LCD Remote Control TransmitterSecond Carbine Security System Operation Batteries Replacement Parts and AccessoriesCredit Card or Money Order Only Parts and Accessories Order FormLimited Lifetime Warranty Copyright 2006 Magnadyne Corporation
Top Page Image Contents