Programming the LCD Transmitter
Press Buttons at the Same Time: Then Press Button Within: | System Function | ||
+ |
|
| Switching to 2nd Vehicle |
| 5 Sec. | or Returning to 1st | |
|
|
| Vehicle Operation |
|
|
|
|
+ |
| 5 Sec. | Melody / Vibration Mode |
|
|
|
|
+ |
| 5 Sec. | Power Save Mode |
|
|
|
|
|
|
| LCD Screen Lamp |
|
|
| Turns On for Five Seconds |
| + | 3 Sec. | System Status Check |
|
|
|
|
| + | 3 Sec. | Clear the Flash Icon |
| and Melody Sound | ||
|
|
| |
Battery Replacement |
|
|
The LCD remote control is powered by a 1.5 Volt | ||
AAA Alkaline battery. When the power of the | ||
battery weakens the battery icon | will be | |
displayed on the screen. When the old battery is | ||
replaced with a new one, there will be a beep to | ||
indicate the power is up. To replace the battery, | ||
follow the steps in the illustration at left. |
| |
Note: Press the | button two times when the | |
battery compartment is empty, then insert the | ||
new battery. |
|
|
Interference |
|
|
The transmission range may decrease if the system encounters interference from tall structures or stronger radio frequencies such as
LED Indicator
LED | Function |
OFF | System is Disarmed |
|
|
Slow Flashing | System is Armed |
|
|
Fast Flashing | System in Automatic Arming |
|
|
On Solid | System in Valet Mode |
|
|
2 Flashes - Pause | Zone 2, Trigger on Trunk/Hook |
|
|
3 Flashes - Pause | Zone 3, Trigger on Door Switch |
|
|
4 Flashes - Pause | Zone 4, Trigger on Shock Sensor |
|
|
5 Flashes - Pause | Zone 5, Trigger on Ignition Switch |
|
|
6