Samsung SP-L300 manual Connecting an AV device using a D-Sub cable

Page 22

First, check that the AV device and your projector are turned off.

Connect the [HDMI/DVI IN] terminal at the back of the projector to the DVI output terminal of the digital output device using an HDMI/DVI cable.

-When connecting to the HDMI output terminal of the digital output device, use an HDMI cable.

-For the supported input signals, refer to "AV Timing(HDMI)".

Connect the [PC 1/DVI AUDIO IN] terminal of the projector to the Audio out terminal of your digital output device using an audio cable (Not supplied).

- If it is connected with a HDMI cable, connecting an audio cable (Not supplied) is not needed.

Connecting an AV device using a D-Sub cable

First, check that the AV device and your projector are turned off.

Connect the [PC IN (1 or 2)] terminal at the back of the projector to the D-Sub terminal of your AV device using a D-Sub cable.

- For supported input signals, refer to the "AV Timing (D-Sub)".

Connect the [PC 1/DVI AUDIO IN] or [AUDIO IN 2] terminal at the back of the projector to the Audio out terminal of your AV device using an audio cable (Not supplied).

Connecting a component output AV device

Image 22

Contents Page Insert the power plug firmly so that it does not come loose Keep the power cord away from heaters Place the product on the ground carefully There is a danger of fire or explosion Correct disposal of batteries in this product Europe only An optical engine adopting new LCD technology Front/Upper SideLens cover UnpackingInformation Clearing Indicator ProblemsLED Indications ClassificationStateCenter Rear SideMenu PowerMove Exit MuteReturn VOLResolution Supported Display Modes PC Timing D-Sub/HDMIMHz AV Timing D-SubFormat AV Timing VIDEO/S-VIDEOPage Installing the Projector Zoom and Focus AdjustmentVertical Leveling with Adjustable FeetScreen Size and Projection Distance YmmScreen Rear of Projector Connecting a PC using a D-Sub cable Connecting a PC using a HDMI/DVI cableConnecting an External Monitor Connecting an HDMI-Compatible DeviceConnecting an AV device using a D-Sub cable Connecting a component output AV deviceConnecting using a Video/S-Video cable Connecting an External Speaker Turning on the projector Selecting an input sourceDescription Screen DescriptionPlay/Stop AdjustmentPlay/Stop Normal Color Temperature Offset GainFor the RGB signal of Hdmi mode Zoom1Install Maximum and then perform Fine Adjustment againDefault settings Fine Used to fine tune the PC screenAuto Rgbpc Rgbav YPbPrAV Logo Blue BlackUsage Screen Adjustment Off 10 min 20 min 30 min Menu and Remote Control Installation and ConnectionScreen and External Source Page To clean the interior of the projector To clean the exterior and lens of the projectorLamp Replacement Lamp Replacement Procedure Replacing and Cleaning the FilterNorth America Ventilating openingsLatin America Europe Asia PacificMiddle East & Africa