Samsung SP-L300 manual Keep the power cord away from heaters

Page 3

Always unplug the unit by holding the power plug. Pulling the power cable may damage the inside of it.

zThere is a danger of fire.

Unplug the power plug before cleaning the product.

zThere is a danger of electric shock or fire.

Power Related Installation Related Cleaning and Use Related

TO PREVENT THE SPREAD OF FIRE, KEEP CANDLES OR OTHER OPEN FLAMES AWAY FROM THIS PRODUCT AT ALL TIMES.

zThere is a danger of fire.

When installing the product in a cabinet or on a shelf, make sure the front end of the base does not protrude.

zDropping the product may damage it or cause injury.

Keep the power cord away from heaters.

zThe coating of the power cord may melt and cause electric shock or fire.

Do not install the product in locations exposed to oil, smoke, moisture or water (rainwater), or in a vehicle.

zThere is a danger of electric shock or fire.

Do not install the product in locations with poor ventilation such as a bookshelf, closet, etc.

zAn increase in the internal temperature may cause a fire.

Do not install on an unstable location, or on a stand smaller than the product.

Image 3
Contents Page Insert the power plug firmly so that it does not come loose Keep the power cord away from heaters Place the product on the ground carefully There is a danger of fire or explosion Correct disposal of batteries in this product Europe only Front/Upper Side An optical engine adopting new LCD technologyUnpacking Lens coverClassificationState Clearing Indicator ProblemsLED Indications InformationRear Side CenterPower MenuMove VOL MuteReturn ExitSupported Display Modes PC Timing D-Sub/HDMI ResolutionAV Timing VIDEO/S-VIDEO AV Timing D-SubFormat MHzPage Zoom and Focus Adjustment Installing the ProjectorYmm Leveling with Adjustable FeetScreen Size and Projection Distance VerticalScreen Rear of Projector Connecting a PC using a HDMI/DVI cable Connecting a PC using a D-Sub cableConnecting an HDMI-Compatible Device Connecting an External MonitorConnecting a component output AV device Connecting an AV device using a D-Sub cableConnecting using a Video/S-Video cable Connecting an External Speaker Selecting an input source Turning on the projectorScreen DescriptionPlay/Stop Adjustment DescriptionPlay/Stop Zoom1 Color Temperature Offset GainFor the RGB signal of Hdmi mode NormalFine Used to fine tune the PC screen Maximum and then perform Fine Adjustment againDefault settings InstallLogo Blue Black Auto Rgbpc Rgbav YPbPrAVUsage Screen Adjustment Off 10 min 20 min 30 min Installation and Connection Menu and Remote ControlScreen and External Source Page To clean the exterior and lens of the projector To clean the interior of the projectorLamp Replacement Replacing and Cleaning the Filter Lamp Replacement ProcedureVentilating openings North AmericaLatin America Asia Pacific EuropeMiddle East & Africa