Samsung SP-L300 manual Connecting a PC using a D-Sub cable, Connecting a PC using a HDMI/DVI cable

Page 20

Connecting a PC using a D-Sub cable

Check that your PC and projector are turned off.

Connect the [PC IN (1 or 2)] terminal at the back of the projector to the D-Sub terminal of your PC using a D-Sub cable. - For the supported input signals, refer to "PC Timing(D-Sub/HDMI)".

Connect the [PC 1/DVI AUDIO IN] or [AUDIO IN 2] terminal at the back of the projector to the Audio out terminal of your PC using an audio cable (Not supplied).

Connecting a PC using a HDMI/DVI cable

Check that your PC and projector are turned off.

Connect the [HDMI/DVI IN] terminal of the projector to the DVI terminal of your PC using a HDMI/DVI cable (Not supplied).

-When connecting to the HDMI terminal of your PC, use an HDMI cable (Not supplied).

-For the supported input signals, refer to "PC Timing(D-Sub/HDMI)".

Connect the [PC 1/DVI AUDIO IN] terminal of the projector and the Audio out terminal of your PC using an audio cable (Not supplied).

- If it is connected with an HDMI cable, connecting an audio cable (Not supplied) is not needed.

Image 20

Contents Page Insert the power plug firmly so that it does not come loose Keep the power cord away from heaters Place the product on the ground carefully There is a danger of fire or explosion Correct disposal of batteries in this product Europe only An optical engine adopting new LCD technology Front/Upper SideLens cover UnpackingClearing Indicator Problems LED IndicationsInformation ClassificationStateCenter Rear SideMove PowerMenu Mute ReturnExit VOLResolution Supported Display Modes PC Timing D-Sub/HDMIAV Timing D-Sub FormatMHz AV Timing VIDEO/S-VIDEOPage Installing the Projector Zoom and Focus AdjustmentLeveling with Adjustable Feet Screen Size and Projection DistanceVertical YmmScreen Rear of Projector Connecting a PC using a D-Sub cable Connecting a PC using a HDMI/DVI cableConnecting an External Monitor Connecting an HDMI-Compatible DeviceConnecting an AV device using a D-Sub cable Connecting a component output AV deviceConnecting using a Video/S-Video cable Connecting an External Speaker Turning on the projector Selecting an input sourcePlay/Stop Screen DescriptionPlay/Stop AdjustmentDescription Color Temperature Offset Gain For the RGB signal of Hdmi modeNormal Zoom1Maximum and then perform Fine Adjustment again Default settingsInstall Fine Used to fine tune the PC screenUsage Logo Blue BlackAuto Rgbpc Rgbav YPbPrAV Screen Adjustment Off 10 min 20 min 30 min Screen and External Source Installation and ConnectionMenu and Remote Control Page Lamp Replacement To clean the exterior and lens of the projectorTo clean the interior of the projector Lamp Replacement Procedure Replacing and Cleaning the FilterLatin America Ventilating openingsNorth America Europe Asia PacificMiddle East & Africa