Hitachi 65SWX20B, 57SWX20B, 51SWX20B, 65TWX20B, 57TWX20B Connecting A/V Network, Mouse

CONNECTING A/V NETWORK

Your Hitachi Television is equiped with an A/V Network feature. This feature helps to control your external Audio/Video equipment (VCR, Set Top Box, DVD, etc.). Once this is setup, it allows your IR Mouse connector to control your equipment using your Hitachi TV Remote Control. You can use your Hitachi remote control to control the Audio/Video equipment command without the equip- ment’s remote control.

The Television rear panel has 2 IR BLASTER jacks. Each IR Mouse cable can connect up to 2 external Audio/Video components. Therefore, you can connect the Television with up to four components. Please see the following example of an A/V Network setup between your Hitachi Television and external Audio/Video equipment (VCR and DVD Player).

CONNECTING EXTERNAL AUDIO/VIDEO COMPONENTS TO IR BLASTER FOR A/V NETWORK

1.Connect your external Audio/Video components to the Rear Panel jacks as shown on pages 13~17.

2.Connect the IR Mouse cable to the IR BLASTER input of the Television’s rear panel.

3.Place the IR mouse in front of the infrared sensor of the external components you wish to control.

IR

Sensor

DVD Player

IR			OUTPUT
Mouse		PR/CR PB/CB		Y	L	R
ANT A
			DVI-HDTV
		PR	PB	Y
	INPUT 1
TO		R	(MONO)/L
CONVERTER
		PR	PB	Y/VIDEO
ANT B	INPUT 2	R	(MONO)/L
				AUDIO
		R	(MONO)/L	VIDEO		S-VIDEO
	INPUT 3
AUDIO
TO HI-FI
CENTER		R	(MONO)/L	VIDEO		S-VIDEO
	INPUT 4
IN
IR
BLASTER		R	L	VIDEO		S-VIDEO
L	MONITOR
	OUT
		AUDIO
R
		R	L	V
		OUTPUT
IR
Sensor
		VCR
IR
Mouse

NOTES: 1. The Rear Panel has two IR BLASTER inputs which can control up to a total of four external components.

2.The IR Mouse must be placed in front of the external components IR sensor for the A/V Network to work.

3.The correct codes must be entered for each of the Audio/Video components for the A/V Network to function properly (see page 20).

4. Press the A/V NET button on the remote control. Use THUMB STICK or	to highlight the component you wish to set up.
Use THUMB STICK to enter component’s “SOFT KEY” control button.	The A/V Network Setup Wizard will automatically

start upon the very first use. You can access the Setup Menu Wizard again in the future by pressing the A/V net button and selecting SETUP.

VCR	POWER	CH	CH
Set Top Box			SETUP
Cable Box
Amplifier	TV/VCR
DVD			MORE
Move

18