SETUP
Video 2 Auto Link
Use this function to automatically turn the TV on and tune to Video2 when it detects a video signal to input 2.
Setup |
Set The Inputs |
Video1 Rename |
Video2 Rename |
Video2 Auto Link |
Video3 Rename |
Video4 Rename |
Video5 Rename |
Move SEL Select |
Setup |
Set The Inputs |
Video2 Auto Link |
Auto Input Signal Sensor |
Remote Control Sensor |
Off |
Move SEL Select |
THUMB
STICK
SELECT
THUMB
STICK
Setup |
Set The Inputs |
Video2 Auto Link |
Auto Input Signal Sensor |
Remote Control Sensor |
Off |
Move SEL Return |
Use THUMB STICK or , then press down on THUMB STICK to change AUTO LINK setting.
When AUTO INPUT SIGNAL SENSOR is selected, the TV will turn on and tune to Video2 automatically, when the Video2 input device is turned on. This is convenient when you want to watch a movie with your VCR, laserdisc player, or DVD player.
When REMOTE CONTROL SENSOR is selected, the TV will turn on and switch to Video2 automatically when the Video2 input device is turned on and the VCR, laserdisc, or DVD play button on your remote control is pressed.
This is convenient when you want to record a movie with your VCR and watch it later.
Select Off to disable this function.
Press EXIT to quit menu.
NOTES: 1. Once the TV has been turned on using the AUTO LINK feature, it must be reset before AUTO LINK is used again. To do this, turn your VCR, laserdisc, or DVD player OFF. This feature is now reset and will turn on your TV as described above.
2.When using REMOTE CONTROL SENSOR mode, any remote control button will substitute for your video input device play button. However, intended operation is for use with your VCR, laserdisc, or DVD play button.
3.If no remote control button is pressed after the TV is turned on by AUTO LINK, the TV will automatically turn off after three hours.
60