Hitachi 65TWX20B, 57SWX20B Using the Remote to Control Cable BOX Functions, Cable CBL button

USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS

Operating the precoded function for your cable box.

This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system of your cable box. (refer to page 37)

1.Turn ON your cable box.

2.Aim the remote control at the front of your cable box.

3.Press and release the Cable (CBL) button to switch to Cable pre-coded mode.

4.Hold down the CBL button on the remote and enter the two digit preset code that matches your cable box as shown on page 37. The indicator light will flash 3 times if the code was accepted.

5.Aim the remote at the cable box and press the POWER button. The remote will turn off your cable box when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off, try a different two digit preset code.

6.The remote will now control your Cable box.

NOTES:

1.If your cable box cannot be operated after performing the above procedures, your cable box code has not been precoded into the remote.

2.In the unlikely event that your cable box cannot be operated after performing the above procedures, please consult your cable box operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

4.The LAST CH button will act as the cable box ENTER button if required.

5.The SLEEP button will act as your cable box ‘100’ button if required.

6.The ANT button will act as the TV/STB button when in STB mode.

	POWER
TV	VCR	CBL
		STB
	SOURCE WIZARD
DVD	CD	TAPE
		AMP

1 2 3

4 5 6

7 8 9

SLEEP			0				INFO
C.C.		A/V NET			ASPECT		VIRTUAL
ANT									HD
	U		E	X
	EN				IT
	M
VOL		SELECT				CH
	M				CH
SVCS	UT	E	LAST				D
VCR						SCH
	PLUS+
VID1			GUIDE/TV				VID	5
VID 2			VID 3		VID	4
PIP		PIP CH				FREEZE
			PIP ACCESS
PIP MODE			SWAP			VIDEO

CABLE (CBL) button

This button allows the remote to control your cable box by setting it to CABLE mode.

PRECODED CABLE BOX buttons

These buttons transmit the chosen precoded cable codes.

EXCLUSIVE TV buttons

These buttons are for operating the TV.

REC

CLU-5722TSI

MY CABLE BOX CODE IS:

NOTE: Refer to instruction manual of the Cable Box for operation of the buttons exclusively for the Cable Box.

32