Hitachi 57TWX20B, 57SWX20B, 51SWX20B, 65TWX20B, 65SWX20B Network Setup Wizard, Back Next

A/V NETWORK SETUP WIZARD

5.Follow the steps below to setup your A/V network (See page 20 for A/V Network Codes).

There are six steps in the setup procedure (VCR setup example below).

HITACHI AV NET Wizard (step 1 of 6)

This Wizard helps you with

VCR connections and settings.

Would you like to setup or

modify your VCR?

BACK NEXT

HITACHI AV NET Wizard (step 2 of 6)

Follow the digrams shown in Hitachi’s

Easy Graphic Guide to connect your VCR.

Carefully position the IR “mouse” in front of your VCR as shown in the diagrams.

BACK NEXT

HITACHI AV NET Wizard (step 3 of 6)

Find your VCR

4-digit manufacturers code

and enter it here - - - -

(Enter Code “9999” to uninstall)

BACK		NEXT
	Proper Code Entered
		from page 20.

HITACHI AV NET Wizard (step 4a of 6)

	Which TV Rear Panel Input
	is connected to your VCR?
(	) ANT A		(	) INPUT 3
(	) ANT B		(	) INPUT 4
(	) INPUT 1		(	) INPUT 5
(	) INPUT 2
		BACK	NEXT

HITACHI AV NET Wizard (step 5 of 6)

Turn ON your VCR then press

each of the 3 function keys below.

Your VCR should respond to one of these

keys. Now press NEXT to continue.

POWER		PLAY		CH UP
	BACK		NEXT

HITACHI AV NET Wizard (step 6 of 6)

Did your VCR respond to

POWER, PLAY or CH UP?

Press DONE to finish this wizard or

HELP to trouble shoot settings.

HELP DONE

HELP

TROUBLE SHOOTING

Please check connections shown in the EASY GRAPHIC GUIDE.

If connections are correct,

try a different manufacturers code

for your VCR	0 4 3 6
BACK	NEXT

If Error

ANT A/B

DONE

ATTENTION

The 4-digit code did not match AV Net’s library. Please check and re-enter a valid code - - - -

BACK NEXT

HITACHI AV NET Wizard (step 4b of 6)

Which RF channel does your VCR

use to send video to the TV?

( ) Channel 03

( ) Channel 04

BACK NEXT

HITACHI AV NET Wizard

Congratulations!

Your VCR is now conected

to your AV network.

From Step 3, once you enter “9999”, the following message appears.

HITACHI AV NET Wizard (step 3b of 6)

This will uninstall VCR on INPUT 1.

Would you like to proceed?

BACK YES

6.Enter “9999” to uninstall the equipment from your A/V Network.

7.See Remote Control A/V NET button usage on page 24.

NOTES: 1. If your equipment cannot be operated after performing the above procedures, your equipment code has not been pre- coded into the A/V Net.

2.In the unlikely event that your equipment receiver cannot be operated after performing the above procedures, please consult your equipment receiver operating guide.

19