Hitachi 57SWX20B Using Your Remote To Control Additional Audio Equipment, Precoded Audio Buttons

USING YOUR REMOTE

TO CONTROL ADDITIONAL AUDIO EQUIPMENT

Operating the precoded function for your Audio component.

This remote is designed to operate different types of Audio component. You must first program the remote to match the remote system of your Audio component. (refer to page 37 for pre-codes)

1.Turn ON your Audio component you wish to control with the Remote.

2.Aim the remote control at the front of your Audio component.

3.Press and release the CD, TAPE or AMP button (Audio buttons) to switch to Audio component pre-coded mode.

4.Hold down the CD, TAPE or AMP button on the remote and enter the two digit preset code that matches your Audio component, as shown on page 37. The indicator light will flash 3 times if the code was accepted.

5.Aim the remote at the Audio component and press the POWER button. The remote will turn off your Audio component when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your Audio component. If the Audio component does not turn off, try a different two digit preset code.

6.The remote will now control your Audio component.

7.Repeat steps 1 - 6 if you wish to program the remote to control another Audio component. Be sure to use a different Audio button on the remote, since only one component can be programmed per button.

NOTES:

1.If your Audio component cannot be operated after performing the above procedures, your Audio component’s code has not been precoded into the remote.

2.In the unlikely event that your Audio component cannot be operated after performing the above procedures, please consult your Audio equipment operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

	POWER
TV		VCR		CBL		STB
		SOURCE WIZARD
DVD		CD	TAPE			AMP
	1	2				3
	4	5				6
	7	8				9
SLEEP		0				INFO
T	C.C	A/V NET			ASPECT VIRT
	.						UAL
AN
								HD
		U	E	X	IT
		EN
	M
VOL		SELECT				CH

CD, TAPE, AMP Buttons

These buttons allow the remote to control your Audio equipment by setting it to Audio mode.

SV	M	UTE	LAST		CH	HD
CS
VCR						SC
	PLUS+
V				GUIDE/TV		5
ID1						VID
VID 2			VID 3		VID	4
PIP		PIP CH				FREEZE
			PIP ACCESS
PIP MODE			SWAP			VIDEO

PRECODED AUDIO Buttons

These buttons transmit the chosen precoded Audio component codes.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

REC

CLU-5722TSI

MY AUDIO EQUIPMENT CODE IS:

CD

TAPE

AMP/RCVR

NOTE: Refer to instruction manual of the Audio equipment for operation of the buttons exclusively for the Audio equipment.

35