Mitsubishi Electronics WS-B55 manual Antenna or Wall Outlet Cable for Analog Broadcasts, Cable Box

Connecting an Analog Antenna, Wall Outlet Cable, or Cable Box, cont’d.

Antenna or Wall Outlet Cable for

Analog Broadcasts.

(Figure 2)

For antennas with twin flat lead

1.For antenna with twin flat leads, connect the 300- Ohm twin leads to the transformer.

2. Push the 75-Ohm side of the transformer onto ANT-A on the TV back panel.

Note: 300-Ohm to 75-Ohm matching transformers are not provided with the TV. They should be available at most electronic stores.

For cable or antenna with coaxial lead

3.Connect the incoming cable to ANT-A on the TV back panel.

Figure 2. Connecting antenna or wall outlet cable for analog broadcasts.

Mitsubishi strongly recommends against using antennas with twin flat leads. Twin flat lead antenna wires are subject to interference which may adversely affect the performance of the TV. We recommend using coaxial antenna cable.

Cable Box

(Figure 3)

1.Connect the incoming cable to ANT-A on the TV back panel.

Note: Connect two coaxial cables as follows:

2.One from LOOP-OUT on the TV back panel to IN on the cable box back panel.

3.One from OUT on the cable box back panel to ANT-B on the TV back panel.

Figure 3. Connecting the cable box.

18