Mitsubishi Electronics WS-48511, WS-B55, ws-65712 manual Mitsubishi Projection TV Limited Warranty

Page 87

MITSUBISHI PROJECTION TELEVISION LIMITED WARRANTY

MITSUBISHI DIGITAL ELECTRONICS AMERICA, INC. (“MDEA”) warrants to the original purchaser of this television that if purchased from an authorized MITSUBISHI Audio/Video Dealer, should it prove defective by reason of improper workmanship and/or material:

a. Parts. The lenticular (i.e. front picture) screen and/or the DiamondShield™ is warranted against defects in materials and workmanship for a period of 30 days. All other parts (except any software incorporated into this television) are warranted for a period of one year from the date of the original purchase at retail. We will repair or replace, at our option, any defective part without charge for the part. Parts used for replacement may be replaced with those of like kind and quality and may be new or remanufactured. Parts used for replacement are warranted for the remainder of the original warranty period.

b. Embedded Software. MDEA warrants that all software incorporated into this television set (the “Embedded Software”) will perform in accordance with the functional description of Embedded Software in all material respects, but MDEA does not warrant that the Embedded Software is error-free. MDEA also does not warrant that the Embedded Software will be compatible under IEEE 1394 AV/C and HAVi software standards with products produced by any other manufacturer. The warranty contained in this section shall continue for a period of one year. If, after prompt notice within the warranty period, MDEA determines that the Embedded Software has failed to perform in accordance with such functional description in all material respects and if such failure is not due to accident, misuse, modification or misapplication of the Embedded Software, then MDEA shall modify or replace the nonconforming Embedded Software at no charge to you, which at MDEA’s sole discretion may be fulfilled by means of modification or replacement software contained on a replacement memory card for Customer installation. The foregoing shall be MDEA’s sole obligation to you under this limited warranty. All rights under this limited warranty on the Embedded Software also subject to your compliance with the terms of the Software License Agreement applicable to this television, and this limited warranty on the Embedded Software shall be null and void if the Embedded Software is modified or changed in any manner except as specifically authorized by MDEA.

c. Labor. For 30 days after the original purchase at retail, we will repair or replace, at our option, the lenticular screen if it proves defective. For certain items that are designed to be replaced by the consumer, including (but not limited to) the Diamond Shield™ and/or some Embedded Software, the consumer is solely responsible for any replacement labor. For all other parts, we will provide the labor for a warranty repair by an authorized MITSUBISHI service center without charge for one year from the original date of purchase at retail.

d. Notice. To obtain warranty service, you must notify an authorized MITSUBISHI service center of any defect within the applicable warranty time period.

1. TO OBTAIN WARRANTY SERVICE:

a. Contact your nearest authorized MITSUBISHI service center whose name and address can be obtained from your MITSUBISHI dealer or by writing or calling MDEA at the address and telephone number provided below.

b. Warranty service will be provided in your home or, if required, at an authorized service shop, provided that your television is located within the geographic territory customarily covered by an authorized MITSUBISHI service center. If not, you must either deliver your television to an authorized service location at your own expense, or pay for any travel and/or transportation costs the service center may charge to and from your home. Actual service labor will be provided without charge.

c. Proof of purchase date from an authorized MITSUBISHI dealer is required when requesting warranty service. Present your sales receipt or other document which establishes proof and date of purchase. THE RETURN OF THE OWNER REGISTRATION CARD IS NOT A CONDITION OF WARRANTY COVERAGE. However, please return the Owner Registration Card so that we can contact you should a question of safety arise which could affect you.

2.THIS WARRANTY DOES NOT COVER damage to Diamond Shield, Lenticular screen or Fresnel lens, screen frame, cosmetic damage or to any other product where such damage is caused by unauthorized modification, alteration, repairs to or service of the product by anyone other than an authorized MITSUBISHI service center; physical abuse to or misuse of the product (including any failure to carry out any maintenance as described in the Owner’s Guide or any product damaged by excessive physical or electrical stress); any products that have had a serial number or any part thereof altered, defaced or removed; product use in any manner contrary to the Owner’s Guide (including uneven picture tube aging and imprinted images on the viewing screen); freight damage; or any damage caused by acts of God or other factors beyond the reasonable control of MDEA, such as power surge damage caused by electrical system or lightning. This warranty also excludes service calls where no defect in the product covered under this warranty is found, service calls related to unsatisfactory audio or visual reception or signal unless caused by a defect in the product that is covered under this warranty, all costs, expenses or any other damages arising from product installation, or set-ups, any adjustments of user controls (including convergence, contrast, brightness, color, tint, fine tuning, sharpness), other adjustment necessary

to prepare the unit for display or use, connection with any external audio receiver, antenna, cable or satellite systems, or service of products purchased or serviced outside the U.S.A. Please consult the operating instructions contained in the Owner’s Guide furnished with the product for information regarding user controls.

3.ANY EXPRESS WARRANTY NOT PROVIDED HEREIN, AND ANY REMEDY WHICH, BUT FOR THIS PROVISION, MIGHT ARISE BY IMPLICATION OR OPERATION OF LAW, IS HEREBY EXCLUDED AND DISCLAIMED. THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR ANY PARTICULAR PURPOSE ARE EXPRESSLY LIMITED TO A TERM OF ONE YEAR.

4.UNDER NO CIRCUMSTANCES SHALL MDEA BE LIABLE TO PURCHASER OR ANY OTHER PERSON FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER ARISING OUT OF BREACH OF WARRANTY, BREACH OF CONTRACT, OR OTHERWISE.

5.Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental, special or consequential damages, so the above limitations or exclusions may not apply to you.

6.This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

7.BEFORE REQUESTING SERVICE, please review the instruction booklet to insure proper installation and correct customer control adjustment. If the problem persists, contact your nearest MITSUBISHI Dealer for the name(s) of authorized MITSUBISHI Service Center(s). If you are unable to obtain this information, please call 800-332-2119, or write us at the address below.

MITSUBISHI DIGITAL ELECTRONICS AMERICA, INC.

9351 Jeronimo Road

Irvine, CA 92618-1904

Mitsubishi Projection TV Limited Warranty

87

Image 87
Contents Owner’s Guide Risk of Electric Shock This Owner’s Guide Important SafeguardsPower-Cord Protection CleaningAccessories Power SourceSafety Check Power LinesDamage Requiring Service Replacement PartsConsumer Relations This Section Our Thanks Unpacking Your New TV Special FeaturesPage Chapter TWO Front Control Panel System ResetPower/Timer ResetBack Panel IR Emitter-Home Theater Control Output Antenna DTV ANT-DTVIEEE-1394 Input/Output Digital Audio OutputReceiver Input by Manufacturer Connecting External Devices & NetCommand SetupNetCommand Compatible Legacy Devices NetCommand Supported DevicesSeparate UHF and VHF Antennas Antenna or Wall Outlet Cable for Digital BroadcastsFor cable or antenna with coaxial lead Antenna or Wall Outlet Cable for Analog BroadcastsCable Box For antennas with twin flat leadAdding Composite Video or an S-Video with Audio Connections Connecting an Analog VCRVCR to Analog Antennas or Wall Outlet Cable Figure VCR to Cable Box FigureConnecting an A/V Receiver Connecting an Audio/Video Surround Sound ReceiverConnecting a DVD Player DVD Player with Component VideoVideo Satellite Receiver DTV Receiver/TV Back panel Connecting an External Digital TV DTV or Hdtv ReceiverDTV Connectors and Adaptors External DTV Receiver with Component Video ConnectionsConnecting an External Digital TV TV or HTV Receiver, External DTV Receiver with RGB Video ConnectionsDTV Receiver / TV Back Panel Steps 2-4 Apply both 1A and 1B Connecting a Computer with a VGA Monitor OutputConnecting the IR-Home Theater Control and IR Repeater Connecting a ComputerImportant Notes Back Button NetCommand Setup Getting StartedCancel Button Radio Buttons ButtonsDevices Programming the Remote Control to Control NetCommandTV Control and NetCommand 935NetCommand Setup Language ScreenInformation Screen VCR Screen NetCommand Setup, cont’dReceiver Screen Cable Box ScreenDBS Screen Camcorder ScreenDVD Screen Finish Screen Review ScreenChange Edit NetCommandEdit NetCommand Screen AddInitial Edit NetCommand, cont’dDelete ReviewName Screen RF Connection for Cable ScreenFixed Channel Screen Connection for Device Screen Monitor Out to AVR ScreenMonitor Out to VCR Screen AVR to VCR Connection Screen Input-DTV Connection ScreenIR Code for Device Screen Chapter Three Characters or move one space backward 3D Graphical Menu SystemVideo Section Power On/Off DevicesDevice Selection Menu Audio Section Device SectionPIP Device Selection Menu PIP/POP Selection MenuClock Menu Setup MenuMenu Screens Overview Antenna MenuAudio/Video Menu Timer MenuCaptions Menu Chip Lock MenuSetup Menu Edit NetCommand Icon Position Edit NetCommand ButtonIcon Position Menu Setup Menu Convergence Reset Factory Defaults MenuConvergence Menu Advanced Convergence Menu Language MenuTransport Menu For ANT-A or ANT-B MemoryChannel NameUsing The Remote Control Antenna Menu SuperQuickView SQVSQV SuperQuickView Daylight Savings Time Clock Menu Auto or Manual Clock SettingClock Setting Auto Clock Setting ManualCaptions Menu Analog and Digital Captions Captions Menu Digital Captions Settings Chip Chip Lock Menu PasscodeEntry Passcode ScreenChip Lock Menu V-Chip Definitions Chip Signal InformationFront Button Lock Chip Menu Lock By Time and Front Button LockLock By Time Lock by Time, Lock Time, and Unlock TimeDevice Timer Menu Setting The TimerTimer On/Off Set TimeVideo Mute Memory ResetAudio/Video Settings Using the Audio and Video Buttons on the Remote ControlTV Speakers Settings Menu TV SpeakersAudio Settings Setting Descriptions AudioVideo Settings Setting Descriptions VideoChapter Four Overview Remote Control Functions OverviewOperation Remote Control Functions Care and OperationInstalling the Batteries For Best Results from the Remote ControlActivating the PIP and POP Remote Control Functions Channel Selection and Sleep TimerRemote Control Functions Operation of PIP and POP Channel Selection Sleep TimerExchanging Program Images Automatic POP SwitchingChanging PIP/POP Device Changing PIP/Side-by-Side ChannelsDefinitions Remote Control FunctionsPage To Program the Remote to Control NetCommand A/V Products Programming the remote to control your satellite receiver DVD Remote Control Functions Special Functions Video game patterns and scoreboards Appendix a Bypassing the V-Chip Lock Appendix a Bypassing the V-Chip LockBypassing the V-Chip Lock Bypassing Front Button LockPage VGA Input Input Levels and Timing When Used With RGB Video SignalsNetCommand Ieee 1394 & HAVi System Compatibility Component-1 and Component-2 InputsSatellite Receivers Appendix C Remote Control Programming CodesReceivers DVD PlayersCleaning Appendix D Cleaning and ServiceFor further assistance, call 800 Appendix D Cleaning and Service Appendix E Diamond Shield Instructions Installation Appendix F Cabinet Cabinet Separation for Model WS-65511Appendix F Cabinet Separation Following operation should be performed by two people Cabinet Separation for Model WS-65712Troubleshooting Problem Possible SolutionAppendix Appendix G Troubleshooting Digital Antenna On Screen Information DisplaysDisplayInformation ScreenOn HAppendix Analog Antenna or DevicesPage Index S-W Demo ModeMitsubishi Projection Television Limited Warranty Mitsubishi Projection TV Limited WarrantyMitsubishi TV Software Page Page Connection Helpful Hints Mitsubishi Digital Electronics America, Inc 871D357B10