Mitsubishi Electronics WS-65815, WS-55815 manual Single Antenna, Separate UHF and VHF Antennas

Page 16
(not for use with CableCARD™)

Connecting a Single Analog Antenna or Separate UHF and VHF Antennas

Single Antenna

Figure 3

A300-Ohm to 75-Ohm transformer is required. This is not included with the TV.

Separate UHF and VHF Antennas

Figure 4

A UHF/VHF combiner is required. This is not included with the TV.

For antennas with twin flat lead

1.For antenna with twin flat leads, connect the

300-Ohm twin leads to the 300-Ohm to 75-Ohm transformer.

2.Push the 75-Ohm side of the transformer onto ANT-1 MAIN on the TV back panel.

1.Connect the UHF and VHF antenna leads to the UHF/VHF combiner.

2.Push the combiner onto ANT-1 MAIN on the TV back panel.

VHF Antenna

UHF Antenna

(Channels 2-13)

(Channels 14-69)

For antennas with coaxial lead

3.Connect the coaxial lead directly to ANT-1 MAIN on the TV back panel.

Flat Twin Lead

External Antenna or Cable

Flat Twin Lead

300-Ohm

 

 

75-Ohm

FlatTwin

 

 

Coaxial

Lead

 

 

 

 

Cable

3.

 

ANT-1

 

MAIN

2.

– (DTV/CABLE /VHF/UHF) –

1.

TV back panel (section detail)

Optional 300-Ohm

to 75-Ohm

 

Matching Transformer

 

 

TV back panel (section detail)

300 Ohm to

 

75 Ohm

ANT-1

Combiner

MAIN

UHF

 

VHF

2.

 

– (DTV/CABLE /VHF/UHF) –

Back

Side

1.

 

Figure 4. Connecting separate UHF and VHF Antennas

Figure 3. Connecting an Antenna

Mitsubishi strongly recommends against using antennas with twin flat leads. Twin flat lead antenna wires are subject to interference which may adversely affect the performance of the TV. We recommend using coaxial antenna cable.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Projection Television Owner’s Guide Risk of Electric Shock Contents Cleaning AccessoriesPower Source Power-Cord ProtectionPower Lines Damage Requiring ServiceReplacement Parts Safety CheckOur Thanks Mitsubishi Digital Electronics America, IncChapter Television OverviewTV Accessories Special FeaturesMultimedia Access Front Control Panel, Multimedia AccessFront Control Panel IEEE-1394 Input/Output Back PanelDigital Audio Output IR Output-NetCommand CableCARD SlotHdmi or DVI Devices DVI Analog AudioLetterbox top/bottom black bars Side bar imagesNews and stock-market report bars Shopping channel logos & pricing displaysConnecting Connecting External Devices & NetCommand Setup Device Audio and Video Outputs to TV InputsConnecting a Wall Outlet Cable or Cable Box Cable Box compatible with PIP/POPSingle Antenna Separate UHF and VHF AntennasFor antennas with twin flat lead For antennas with coaxial leadVCR to Antenna or Wall Outlet Cable RedConnecting VCR Video and Audio to a Cable Box VCR to a Cable BoxReceiver or Stereo System Satellite Receiver or Other Device with S-VideoDVD Player with Component Video Connecting a DVD Player with Component Video or DVI DeviceDVI Device Hdmi Device External DTV Receiver with Component VideoConnecting the IR Emitter NetCommand IR Emitter NetCommandConnecting Ieee 1394 Devices Pin Style vs -Pin StyleIeee 1394 Device Connection Styles Connection StylesDirect Device-To-Device Style Hub Connection StyleCableCARD Definition and Initial Screen Display Using a CableCARDCableCARD Technology Connecting Helpful Hints NetCommand Setup and Editing NetCommand Pre-Memorized Devices DeviceNetCommand On-Screen Buttons Remote Control Functions Overview FollowingRemote Control FunctionsOperation, Care, Sleep Timer Sleep TimerCare OperationRemote Control Buttons 3D Graphical Menu SystemNetCommand Initial Setup NetCommand Information ScreenDevice Setup Screen Welcome ScreenReview Screen Finish ScreenReceiver Screen Edit NetCommand, Adding an A/V ReceiverReceiver Inputs Receiver Input Learn Screen Receiver Learn ScreenName Screen Monitor Out to AVR ScreenEdit NetCommand, Adding Devices Edit NetCommandAdd Screen Device ScreenDevice Learn Screen Device Advanced Learn ScreenConnection for Device Screen VCR for Recordings ScreenRF Connection for Cable Screen IR Code for Device ScreenChange Screen Delete ScreenDevice Selection Menu Using the Device Menu Button to Display Menus Device MenuIeee 1394 Devices and NetCommand Controlled Recordings Adding Ieee 1394 Devices Automatically Adding Ieee 1394 Devices AutomaticallyNew 1394 Device Screen Name for 1394 Device ScreenIeee 1394 Device Type Screen Connection ScreenDigital Video Signals Digital Audio SignalsDigital Control Signal Ieee 1394 Devices CompatibilityUsing the Guide Button to Display ChannelView and Menus NetCommand Controlled Recordings Record To SetupTime-Delayed Recording Copy-Protected MaterialCancel Current Recordings Record List ScreenDisc Search Track List ScreenNetCommand Controlled Peer-to-Peer Connections What is a Peer-to-Peer Connection?Setting up a Peer-to-Peer Connection Canceling a Current Peer-to-Peer ConnectionDirect VCR Recording from an Antenna or Cable Source Direct VCR RecordingRestrictions for Traditional VCRs MediaCommand and Media Card Playback Media Card SlotsInserting a media card For MP3 or WMA Audio PlaybackMedia Command and Media Card Playback Important Notes TV Menu Screen Operations Main Menu Choices Setup Menu Reset Factory Defaults Menu Advanced ConvergenceNetCommand Menu Antenna Menu SQV SuperQuickView Setting the Clock Timer On/OffTime Menu ManualCaptions Menu Captions MenuAnalog Captions Digital CaptionsFonts SizeColor Opacity FontChip Lock Menu ChipEntry Chip Start Time and V-Chip Stop TimeContent Categories Chip Signal InformationTV Ratings Lock By Time Front Button LockAudioVideo Menu AudioVideoSetting Descriptions Analog and Digital Audio SettingAnalog Only Audio Settings Digital Only Audio SettingsVideo Settings Chapter Format Signals Display FormatsFormat Definitions DVD DefinitionsOriginal Signal Operation of PIP and POP POPPIP large PIP small PIP/POP offDevice Menu with Net Command CH up/downVOL up/down DigitsWhen an Ieee 1394 Device is Viewed or Played Bypassing the V-Chip Lock Appendix a Bypassing the V-Chip LockBypassing Front Button Lock This page intentionally blank Appendix B High Definition Input Connection Compatibility Input Levels and Timing with Component Video SignalsComponent-1 and Component-2 Inputs Appendix CRemote Control Programming Codes Programming the Remote to Control NetCommand A/V ProductsAppendix C Remote Control Programming Codes DVD PlayersCable Boxes and Satellite Receivers ReceiversMitsubishi A/V Receivers Mitsubishi CD Players Not all functions for all modelsAppendix D On Screen Information Displays Analog ProgramDigital Program Digital Ieee 1394 DeviceAppendix E NetCommand Specialized Device Keys Checkbox NameAppendix F Cleaning and Service Diamond Shield Removal Diamond Shield installationFor additional assistance, call 800 For Mitsubishi Dealers and Service Personnel Only Appendix H Cabinet Separation for Model WS-65815Troubleshooting Problem Possible SolutionTroubleshooting Troubleshooting Troubleshooting Demo Mode Additional InformationLicensing Information Index Menu 58 Mitsubishi Projection TV Limited Warranty Mitsubishi Projection Television Limited WarrantyMitsubishi TV Software Mitsubishi Digital Electronics America, Inc 871D406A10

WS-55815, WS-65815 specifications

The Mitsubishi Electronics WS-65815 and WS-55815 are high-quality rear-projection televisions that gained popularity in the early 2000s for their impressive display performance and advanced features. These models were designed to provide an immersive viewing experience, highlighting Mitsubishi's commitment to innovation in the home entertainment market.

One of the standout features of the WS-65815 and WS-55815 is their large screen sizes. The WS-65815 offers a massive 65-inch display, while the WS-55815 comes in at 55 inches. Both models utilize a DLP (Digital Light Processing) technology that delivers exceptional picture quality with vibrant colors and sharp details. DLP technology also contributes to deeper blacks and a higher contrast ratio, enhancing the overall visual experience.

Mitsubishi incorporated a 16:9 aspect ratio in both models, which is ideal for watching widescreen content, such as movies and sports events. The advanced color wheel in these televisions enhances the saturation and chromatic accuracy of the images displayed. Additionally, both models support 1080p resolution, making them compatible with high-definition broadcasts and Blu-ray Disc viewing, ensuring users can enjoy stunning picture clarity.

Another key characteristic of the WS-65815 and WS-55815 is their integrated video processing technology. The units feature a built-in 3D Y/C digital comb filter that significantly improves image quality by reducing artifacts and enhancing detail resolution. The televisions also offer multiple input options, including HDMI and component video, allowing users to connect various devices such as gaming consoles, cable boxes, and DVD players seamlessly.

The design of both models is characterized by a sleek cabinet finish, which allows them to blend seamlessly into modern home décor. Furthermore, the televisions are equipped with a user-friendly remote control with programmable features, enabling easy navigation through channels, inputs, and settings.

In summary, the Mitsubishi Electronics WS-65815 and WS-55815 rear-projection televisions stood out for their impressive screen size, advanced DLP technology, and rich, immersive picture quality. These models remain noteworthy examples of Mitsubishi’s innovation in television technology, making them desirable among enthusiasts even in today’s evolving market.
Top Page Image Contents