Mitsubishi Electronics WS-55815, WS-65815 manual Troubleshooting

Page 91

Troubleshooting, continued

 

Problem

Possible Solution

 

 

 

17.

The TV will not turn on after being plugged in.

• If green light on front panel is blinking, wait for at least one

 

 

minute for the light to turn off, then press Power again.

 

 

 

18.

TV functions do not respond to the remote

• Use the System Reset button as explained at the end of this

 

control or to front panel control and will not

section.

 

Power Off.

 

 

 

 

19.

Name options not available for some channels

• Only memorized analog channels can be named.

 

 

 

20.

When viewing a stopped VCR, white lines are

• Turn off video mute for the VCR.

 

rolling on the screen.

• Begin playing the tape.

 

 

• Change the VCR input to the antenna input.

 

 

 

21.

TV turned itself Off and the light on the Front

• Momentary power fluctuation caused the TV to turn off to prevent

 

Panel started to blink.

damage. Wait for the green light to stop flashing and turn On again.

 

 

• If the TV does not stay turned On, use the System Reset button. If

 

 

this happens frequently, obtain an AC line power conditioner/surge

 

 

protector.

 

 

 

22.

When a Device is selected from the Device

• Make sure the selected device is turned on.

 

Selection menu, the screen is blue

• From the Edit NetCommand® menu select Review setting. Verify that

 

(no signal source).

the inputs are actually connected to the TV . If they are not, either

 

 

change the physical connections on the back panel, or select the

 

 

Change setting on the Edit NetCommand menu to change the TV

 

 

NetCommand’s settings for the connection.

 

 

 

23.

The Device does not respond to button presses

• Remote has not been setup for NetCommand use.

 

from the remote.

• The incorrect manufacturer was selected during setup. Select the

 

 

Change from the NetCommand menu and then select the device to

 

 

display the manufacturer selection. Change if necessary.

 

 

• The device is not supported and keys have not been learned.

 

 

• The requested function is not supported by NetCommand.

 

 

Verify that the function is supported or keys are learned.

 

 

• The IR emitter is incorrectly placed. Make sure the IR emitter is

 

 

facing the IR sensor in the device.

 

 

• The IR emitter is not plugged into the IR emitter output NetCommand.

 

 

• The IR emitter is facing the TV screen, causing double signals. Be

 

 

sure that the IR emitter cannot send to the TV.

 

 

 

24.

The A/V Receiver is the selected audio source

• Check to see if the A/V Receiver power is turned on. After the power

 

but there is no sound.

is turned on, redisplay the Device Selection menu and press ENTER

 

 

to allow NetCommand to correctly select the A/V Receiver input.

 

 

• Check the Review screen in the NetCommand menu to see if the A/V

 

 

Receiver inputs and device correspond to the actual connections on

 

 

the A/V Receiver. If they do not match, either change the actual

 

 

connections, or select Change on the Edit NetCommand menu to

 

 

change the input selection on the Connection screen for the device.

 

 

 

25.

The TV Speaker icon or A/V Receiver icon is

• Select the Change setting from the NetCommand menu, and

 

grayed out and not selectable.

then select the device (for example VCR). Once the Connection

 

 

screen is displayed, check if the audio checkbox is selected for the

 

 

TV input and/or AVR input.

 

 

 

26.

Devices are grayed out in the Device Selection

• A recording is in progress requiring the use of Monitor Out. Cancel

 

menu or the PIP Selection menu.

the recording to select the device.

 

 

• Digital devices (Digital channels,1394 devices and Memory cards)

 

 

cannot display in the PIP or POP.

 

 

 

27.

Cannot see the A/V Receiver menu.

• The A/V Receiver is not connected to any input of the TV. To check

 

 

the A/V Receiver menu temporarily plug into an unused input of the

 

 

TV. Then select Review from the Setup Menu, turn the input On to

 

 

view the A/V Receiver menu.

 

 

 

28.

Screen is black when trying to view digital

• The PerfectColor™ color balance has been incorrectly set. Use the

 

channels or IEEE 1394 device.

Setup menu to reset the color balance sliders.

 

 

 

91

Page 90 Page 92
Image 91
Page 90 Page 92
Contents Projection Television Owner’s Guide Risk of Electric Shock Contents Power-Cord Protection CleaningAccessories Power SourceSafety Check Power LinesDamage Requiring Service Replacement PartsMitsubishi Digital Electronics America, Inc Our ThanksTelevision Overview ChapterSpecial Features TV AccessoriesMultimedia Access Front Control Panel, Multimedia AccessFront Control Panel IEEE-1394 Input/Output Back PanelDigital Audio Output DVI Analog Audio IR Output-NetCommandCableCARD Slot Hdmi or DVI DevicesShopping channel logos & pricing displays Letterbox top/bottom black barsSide bar images News and stock-market report barsConnecting Device Audio and Video Outputs to TV Inputs Connecting External Devices & NetCommand SetupCable Box compatible with PIP/POP Connecting a Wall Outlet Cable or Cable BoxFor antennas with coaxial lead Single AntennaSeparate UHF and VHF Antennas For antennas with twin flat leadRed VCR to Antenna or Wall Outlet CableVCR to a Cable Box Connecting VCR Video and Audio to a Cable BoxSatellite Receiver or Other Device with S-Video Receiver or Stereo SystemDVD Player with Component Video Connecting a DVD Player with Component Video or DVI DeviceDVI Device External DTV Receiver with Component Video Hdmi DeviceIR Emitter NetCommand Connecting the IR Emitter NetCommandPin Style vs -Pin Style Connecting Ieee 1394 DevicesHub Connection Style Ieee 1394 Device Connection StylesConnection Styles Direct Device-To-Device StyleCableCARD Definition and Initial Screen Display Using a CableCARDCableCARD Technology Connecting Helpful Hints NetCommand Setup and Editing Device NetCommand Pre-Memorized DevicesNetCommand On-Screen Buttons Following Remote Control Functions OverviewOperation Remote Control FunctionsOperation, Care, Sleep TimerSleep Timer Care3D Graphical Menu System Remote Control ButtonsWelcome Screen NetCommand Initial SetupNetCommand Information Screen Device Setup ScreenFinish Screen Review ScreenReceiver Screen Edit NetCommand, Adding an A/V ReceiverReceiver Inputs Receiver Learn Screen Receiver Input Learn ScreenMonitor Out to AVR Screen Name ScreenEdit NetCommand Edit NetCommand, Adding DevicesDevice Screen Add ScreenDevice Advanced Learn Screen Device Learn ScreenIR Code for Device Screen Connection for Device ScreenVCR for Recordings Screen RF Connection for Cable ScreenDelete Screen Change ScreenDevice Selection Menu Device Menu Using the Device Menu Button to Display MenusIeee 1394 Devices and NetCommand Controlled Recordings Name for 1394 Device Screen Adding Ieee 1394 Devices AutomaticallyAdding Ieee 1394 Devices Automatically New 1394 Device ScreenConnection Screen Ieee 1394 Device Type ScreenIeee 1394 Devices Compatibility Digital Video SignalsDigital Audio Signals Digital Control SignalUsing the Guide Button to Display ChannelView and Menus Copy-Protected Material NetCommand Controlled RecordingsRecord To Setup Time-Delayed RecordingTrack List Screen Cancel Current RecordingsRecord List Screen Disc SearchCanceling a Current Peer-to-Peer Connection NetCommand Controlled Peer-to-Peer ConnectionsWhat is a Peer-to-Peer Connection? Setting up a Peer-to-Peer ConnectionDirect VCR Recording from an Antenna or Cable Source Direct VCR RecordingRestrictions for Traditional VCRs For MP3 or WMA Audio Playback MediaCommand and Media Card PlaybackMedia Card Slots Inserting a media cardMedia Command and Media Card Playback Important Notes TV Menu Screen Operations Main Menu Choices Setup Menu Advanced Convergence Reset Factory Defaults MenuNetCommand Menu Antenna Menu SQV SuperQuickView Manual Setting the ClockTimer On/Off Time MenuDigital Captions Captions MenuCaptions Menu Analog CaptionsOpacity Font FontsSize ColorChip Start Time and V-Chip Stop Time Chip Lock MenuChip EntryContent Categories Chip Signal InformationTV Ratings Front Button Lock Lock By TimeAudioVideo AudioVideo MenuDigital Only Audio Settings Setting DescriptionsAnalog and Digital Audio Setting Analog Only Audio SettingsVideo Settings Chapter DVD Definitions Format SignalsDisplay Formats Format DefinitionsOriginal Signal PIP small PIP/POP off Operation of PIP and POPPOP PIP largeDigits Device Menu with Net CommandCH up/down VOL up/downWhen an Ieee 1394 Device is Viewed or Played Bypassing the V-Chip Lock Appendix a Bypassing the V-Chip LockBypassing Front Button Lock This page intentionally blank Appendix B High Definition Input Connection Compatibility Input Levels and Timing with Component Video SignalsComponent-1 and Component-2 Inputs Programming the Remote to Control NetCommand A/V Products Appendix CRemote Control Programming CodesDVD Players Appendix C Remote Control Programming CodesMitsubishi CD Players Not all functions for all models Cable Boxes and Satellite ReceiversReceivers Mitsubishi A/V ReceiversDigital Ieee 1394 Device Appendix D On Screen Information DisplaysAnalog Program Digital ProgramCheckbox Name Appendix E NetCommand Specialized Device KeysAppendix F Cleaning and Service Diamond Shield Removal Diamond Shield installationFor additional assistance, call 800 Appendix H Cabinet Separation for Model WS-65815 For Mitsubishi Dealers and Service Personnel OnlyProblem Possible Solution TroubleshootingTroubleshooting Troubleshooting Troubleshooting Additional Information Demo ModeLicensing Information Index Menu 58 Mitsubishi Projection Television Limited Warranty Mitsubishi Projection TV Limited WarrantyMitsubishi TV Software Mitsubishi Digital Electronics America, Inc 871D406A10

WS-55815, WS-65815 specifications

The Mitsubishi Electronics WS-65815 and WS-55815 are high-quality rear-projection televisions that gained popularity in the early 2000s for their impressive display performance and advanced features. These models were designed to provide an immersive viewing experience, highlighting Mitsubishi's commitment to innovation in the home entertainment market.

One of the standout features of the WS-65815 and WS-55815 is their large screen sizes. The WS-65815 offers a massive 65-inch display, while the WS-55815 comes in at 55 inches. Both models utilize a DLP (Digital Light Processing) technology that delivers exceptional picture quality with vibrant colors and sharp details. DLP technology also contributes to deeper blacks and a higher contrast ratio, enhancing the overall visual experience.

Mitsubishi incorporated a 16:9 aspect ratio in both models, which is ideal for watching widescreen content, such as movies and sports events. The advanced color wheel in these televisions enhances the saturation and chromatic accuracy of the images displayed. Additionally, both models support 1080p resolution, making them compatible with high-definition broadcasts and Blu-ray Disc viewing, ensuring users can enjoy stunning picture clarity.

Another key characteristic of the WS-65815 and WS-55815 is their integrated video processing technology. The units feature a built-in 3D Y/C digital comb filter that significantly improves image quality by reducing artifacts and enhancing detail resolution. The televisions also offer multiple input options, including HDMI and component video, allowing users to connect various devices such as gaming consoles, cable boxes, and DVD players seamlessly.

The design of both models is characterized by a sleek cabinet finish, which allows them to blend seamlessly into modern home décor. Furthermore, the televisions are equipped with a user-friendly remote control with programmable features, enabling easy navigation through channels, inputs, and settings.

In summary, the Mitsubishi Electronics WS-65815 and WS-55815 rear-projection televisions stood out for their impressive screen size, advanced DLP technology, and rich, immersive picture quality. These models remain noteworthy examples of Mitsubishi’s innovation in television technology, making them desirable among enthusiasts even in today’s evolving market.
Top Page Image Contents