Mitsubishi Electronics WS-55815, WS-65815 Remote Control FunctionsOperation, Care, Sleep Timer

Page 31

Remote Control Functions:Operation, Care, Sleep Timer

CABLE/DBS/DTV VCR DVD

TV AUDIO

2

1

1 2 3

4 5 6

3POWER

Care

For Best Results from the Remote Control:

7

8

9

 

 

 

 

SUB/CANCEL

4 SQV

0

5 QV

6

7

8

9

10

 

 

 

DEVICE

CH

VOL

MUTE

TV MENU

12

GUIDE

15

 

11

 

14

 

DEVICE

13

 

 

MENU

HOME

 

16

 

17

 

V-CHIP INFO AUDIO VIDEO

1819 20 21

PIP CH PIP/POP

EXCH

SLEEP

22

23

24

25

PIP DEVICE

FORMAT

CONNECT

 

26

27

28

29

REC

PAUSE 30

31 REW/REV

32 PLAY

34

33

FF/FWD

 

STOP

 

Figure 1. Remote Control Overview

Operation

Figure 2

Installing the Batteries:

1.Remove the remote control’s back cover by gently pressing the ribbed tab in the direction of the arrow and sliding off the cover.

2.Load two AA batteries, making sure the polarities (+) and (-) are correct. For best results, insert the negative (-) side first.

AA (alkaline) batteries

AA

AA

Figure 2. Operation: Installing the Batteries

•Be within 20 feet of the equipment.

•Do not press two or more buttons at the same time unless instructed to do so.

•Do not allow unit to get wet or become heated.

•Avoid dropping on hard surfaces.

•Do not use harsh chemicals to clean. Use only a soft, lightly moistened cloth.

•Do not mix new and old batteries.

•Do not heat, take apart or throw batteries into fire.

•Use only AA alkaline batteries.

Hint: If the remote is in the TV layer and will not function, press POWER and 000 (or POWER and 935 if NetCommand® is setup) to reset the remote.

Sleep Timer

Setting the Sleep Timer:

1.Press SLEEP on the remote control.

2.Each press of SLEEP increases the time displayed by 30 minutes, until the maximum value of 120 minutes is reached.

3.After 5 seconds of inactivity, the message will disappear.

4.Press SLEEP to view the remaining time before the timer turns the TV off.

Canceling the Sleep Timer:

1.Press SLEEP to display the on-screen message.

2.Press SLEEP repeatedly until OFF is displayed.

Note: After 5 seconds of inactivity, the message box disappears.

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Projection Television Owner’s Guide Risk of Electric Shock Contents Power-Cord Protection CleaningAccessories Power SourceSafety Check Power LinesDamage Requiring Service Replacement PartsMitsubishi Digital Electronics America, Inc Our ThanksTelevision Overview ChapterSpecial Features TV AccessoriesMultimedia Access Front Control Panel, Multimedia AccessFront Control Panel IEEE-1394 Input/Output Back PanelDigital Audio Output DVI Analog Audio IR Output-NetCommandCableCARD Slot Hdmi or DVI DevicesShopping channel logos & pricing displays Letterbox top/bottom black barsSide bar images News and stock-market report barsConnecting Device Audio and Video Outputs to TV Inputs Connecting External Devices & NetCommand SetupCable Box compatible with PIP/POP Connecting a Wall Outlet Cable or Cable BoxFor antennas with coaxial lead Single AntennaSeparate UHF and VHF Antennas For antennas with twin flat leadRed VCR to Antenna or Wall Outlet CableVCR to a Cable Box Connecting VCR Video and Audio to a Cable BoxSatellite Receiver or Other Device with S-Video Receiver or Stereo SystemDVD Player with Component Video Connecting a DVD Player with Component Video or DVI DeviceDVI Device External DTV Receiver with Component Video Hdmi DeviceIR Emitter NetCommand Connecting the IR Emitter NetCommandPin Style vs -Pin Style Connecting Ieee 1394 DevicesHub Connection Style Ieee 1394 Device Connection StylesConnection Styles Direct Device-To-Device StyleCableCARD Definition and Initial Screen Display Using a CableCARDCableCARD Technology Connecting Helpful Hints NetCommand Setup and Editing Device NetCommand Pre-Memorized DevicesNetCommand On-Screen Buttons Following Remote Control Functions OverviewOperation Remote Control FunctionsOperation, Care, Sleep TimerSleep Timer Care3D Graphical Menu System Remote Control ButtonsWelcome Screen NetCommand Initial SetupNetCommand Information Screen Device Setup ScreenFinish Screen Review ScreenReceiver Screen Edit NetCommand, Adding an A/V ReceiverReceiver Inputs Receiver Learn Screen Receiver Input Learn ScreenMonitor Out to AVR Screen Name ScreenEdit NetCommand Edit NetCommand, Adding DevicesDevice Screen Add ScreenDevice Advanced Learn Screen Device Learn ScreenIR Code for Device Screen Connection for Device ScreenVCR for Recordings Screen RF Connection for Cable ScreenDelete Screen Change ScreenDevice Selection Menu Device Menu Using the Device Menu Button to Display MenusIeee 1394 Devices and NetCommand Controlled Recordings Name for 1394 Device Screen Adding Ieee 1394 Devices AutomaticallyAdding Ieee 1394 Devices Automatically New 1394 Device ScreenConnection Screen Ieee 1394 Device Type ScreenIeee 1394 Devices Compatibility Digital Video SignalsDigital Audio Signals Digital Control SignalUsing the Guide Button to Display ChannelView and Menus Copy-Protected Material NetCommand Controlled RecordingsRecord To Setup Time-Delayed RecordingTrack List Screen Cancel Current RecordingsRecord List Screen Disc SearchCanceling a Current Peer-to-Peer Connection NetCommand Controlled Peer-to-Peer ConnectionsWhat is a Peer-to-Peer Connection? Setting up a Peer-to-Peer ConnectionDirect VCR Recording from an Antenna or Cable Source Direct VCR RecordingRestrictions for Traditional VCRs For MP3 or WMA Audio Playback MediaCommand and Media Card PlaybackMedia Card Slots Inserting a media cardMedia Command and Media Card Playback Important Notes TV Menu Screen Operations Main Menu Choices Setup Menu Advanced Convergence Reset Factory Defaults MenuNetCommand Menu Antenna Menu SQV SuperQuickView Manual Setting the ClockTimer On/Off Time MenuDigital Captions Captions MenuCaptions Menu Analog CaptionsOpacity Font FontsSize ColorChip Start Time and V-Chip Stop Time Chip Lock MenuChip EntryContent Categories Chip Signal InformationTV Ratings Front Button Lock Lock By TimeAudioVideo AudioVideo MenuDigital Only Audio Settings Setting DescriptionsAnalog and Digital Audio Setting Analog Only Audio SettingsVideo Settings Chapter DVD Definitions Format SignalsDisplay Formats Format DefinitionsOriginal Signal PIP small PIP/POP off Operation of PIP and POPPOP PIP largeDigits Device Menu with Net CommandCH up/down VOL up/downWhen an Ieee 1394 Device is Viewed or Played Bypassing the V-Chip Lock Appendix a Bypassing the V-Chip LockBypassing Front Button Lock This page intentionally blank Appendix B High Definition Input Connection Compatibility Input Levels and Timing with Component Video SignalsComponent-1 and Component-2 Inputs Programming the Remote to Control NetCommand A/V Products Appendix CRemote Control Programming CodesDVD Players Appendix C Remote Control Programming CodesMitsubishi CD Players Not all functions for all models Cable Boxes and Satellite ReceiversReceivers Mitsubishi A/V ReceiversDigital Ieee 1394 Device Appendix D On Screen Information DisplaysAnalog Program Digital ProgramCheckbox Name Appendix E NetCommand Specialized Device KeysAppendix F Cleaning and Service Diamond Shield Removal Diamond Shield installationFor additional assistance, call 800 Appendix H Cabinet Separation for Model WS-65815 For Mitsubishi Dealers and Service Personnel OnlyProblem Possible Solution TroubleshootingTroubleshooting Troubleshooting Troubleshooting Additional Information Demo ModeLicensing Information Index Menu 58 Mitsubishi Projection Television Limited Warranty Mitsubishi Projection TV Limited WarrantyMitsubishi TV Software Mitsubishi Digital Electronics America, Inc 871D406A10

WS-55815, WS-65815 specifications

The Mitsubishi Electronics WS-65815 and WS-55815 are high-quality rear-projection televisions that gained popularity in the early 2000s for their impressive display performance and advanced features. These models were designed to provide an immersive viewing experience, highlighting Mitsubishi's commitment to innovation in the home entertainment market.

One of the standout features of the WS-65815 and WS-55815 is their large screen sizes. The WS-65815 offers a massive 65-inch display, while the WS-55815 comes in at 55 inches. Both models utilize a DLP (Digital Light Processing) technology that delivers exceptional picture quality with vibrant colors and sharp details. DLP technology also contributes to deeper blacks and a higher contrast ratio, enhancing the overall visual experience.

Mitsubishi incorporated a 16:9 aspect ratio in both models, which is ideal for watching widescreen content, such as movies and sports events. The advanced color wheel in these televisions enhances the saturation and chromatic accuracy of the images displayed. Additionally, both models support 1080p resolution, making them compatible with high-definition broadcasts and Blu-ray Disc viewing, ensuring users can enjoy stunning picture clarity.

Another key characteristic of the WS-65815 and WS-55815 is their integrated video processing technology. The units feature a built-in 3D Y/C digital comb filter that significantly improves image quality by reducing artifacts and enhancing detail resolution. The televisions also offer multiple input options, including HDMI and component video, allowing users to connect various devices such as gaming consoles, cable boxes, and DVD players seamlessly.

The design of both models is characterized by a sleek cabinet finish, which allows them to blend seamlessly into modern home décor. Furthermore, the televisions are equipped with a user-friendly remote control with programmable features, enabling easy navigation through channels, inputs, and settings.

In summary, the Mitsubishi Electronics WS-65815 and WS-55815 rear-projection televisions stood out for their impressive screen size, advanced DLP technology, and rich, immersive picture quality. These models remain noteworthy examples of Mitsubishi’s innovation in television technology, making them desirable among enthusiasts even in today’s evolving market.
Top Page Image Contents