Mitsubishi Electronics WS-55815, WS-65815 manual SQV SuperQuickView

Page 63

Antenna Menu, continued

SQV (SuperQuickView™)

Using The Menu Screen

Figure 17

SQV (SuperQuickView™) allows you to put together lists of your favorite channels from Antenna-1 and Antenna-2. You can store channels in any of the 9 different SQV memory banks. You can also store the same channel in multiple memory banks. Once you have added a channel to an SQV memory, “SQV” and the memory bank number will appear under the tuned channel number on the TV screen.

Adding SQV Channels

1.Select the channel by pressing ADJUST or using the Channel text box or press CH or .

2.Highlight the bank (SQV1-SQV9).

3.Press ENTER to check mark the selected SQV memory bank.

4.Repeat for additional channels or banks.

Removing SQV Channels

1.Highlight the box for the SQV bank number.

2.Press ENTER to remove the checkmark.

Figure 17. Antenna Menu, SQV (SuperQuickView)

SQV (SuperQuickView™)

Using The Remote Control

Adding SQV channels using the remote control:

1.Press CH , or number buttons to select the channel you want to add to the current SQV memory bank.

2.Press and hold the SQV button for about 2 seconds. When “SQV” and the memory bank number appear under the channel number, the channel has successfully been added.

Removing SQV channels using the remote control:

1.Press the SQV button and then the memory bank number.

2.Press the SQV button repeatedly until you see the desired channel.

3.While the channel number and SQV indicator (with correct bank number) are still displayed on the screen, press CANCEL. If the CANCEL button is not pressed before the SQV indicator disappears automatically, the channel will not be removed.

4.When the SQV indicator disappears, the channel has successfully been removed only from that bank. Other banks remain unchanged.

Viewing and changing SQV banks using the remote control:

1.Press the SQV button.

2.To change memory banks, press a number button within 5 seconds of pressing the SQV button.

3.Press the SQV button repeatedly to cycle through the channels available in that bank.

63

Page 62 Page 64
Image 63
Page 62 Page 64
Contents Projection Television Owner’s Guide Risk of Electric Shock Contents Power-Cord Protection CleaningAccessories Power SourceSafety Check Power LinesDamage Requiring Service Replacement PartsMitsubishi Digital Electronics America, Inc Our ThanksTelevision Overview ChapterSpecial Features TV AccessoriesFront Control Panel, Multimedia Access Multimedia AccessFront Control Panel Back Panel IEEE-1394 Input/OutputDigital Audio Output DVI Analog Audio IR Output-NetCommandCableCARD Slot Hdmi or DVI DevicesShopping channel logos & pricing displays Letterbox top/bottom black barsSide bar images News and stock-market report barsConnecting Device Audio and Video Outputs to TV Inputs Connecting External Devices & NetCommand SetupCable Box compatible with PIP/POP Connecting a Wall Outlet Cable or Cable BoxFor antennas with coaxial lead Single AntennaSeparate UHF and VHF Antennas For antennas with twin flat leadRed VCR to Antenna or Wall Outlet CableVCR to a Cable Box Connecting VCR Video and Audio to a Cable BoxSatellite Receiver or Other Device with S-Video Receiver or Stereo SystemConnecting a DVD Player with Component Video or DVI Device DVD Player with Component VideoDVI Device External DTV Receiver with Component Video Hdmi DeviceIR Emitter NetCommand Connecting the IR Emitter NetCommandPin Style vs -Pin Style Connecting Ieee 1394 DevicesHub Connection Style Ieee 1394 Device Connection StylesConnection Styles Direct Device-To-Device StyleUsing a CableCARD CableCARD Definition and Initial Screen DisplayCableCARD Technology Connecting Helpful Hints NetCommand Setup and Editing Device NetCommand Pre-Memorized DevicesNetCommand On-Screen Buttons Following Remote Control Functions OverviewOperation Remote Control FunctionsOperation, Care, Sleep TimerSleep Timer Care3D Graphical Menu System Remote Control ButtonsWelcome Screen NetCommand Initial SetupNetCommand Information Screen Device Setup ScreenFinish Screen Review ScreenEdit NetCommand, Adding an A/V Receiver Receiver ScreenReceiver Inputs Receiver Learn Screen Receiver Input Learn ScreenMonitor Out to AVR Screen Name ScreenEdit NetCommand Edit NetCommand, Adding DevicesDevice Screen Add ScreenDevice Advanced Learn Screen Device Learn ScreenIR Code for Device Screen Connection for Device ScreenVCR for Recordings Screen RF Connection for Cable ScreenDelete Screen Change ScreenDevice Selection Menu Device Menu Using the Device Menu Button to Display MenusIeee 1394 Devices and NetCommand Controlled Recordings Name for 1394 Device Screen Adding Ieee 1394 Devices AutomaticallyAdding Ieee 1394 Devices Automatically New 1394 Device ScreenConnection Screen Ieee 1394 Device Type ScreenIeee 1394 Devices Compatibility Digital Video SignalsDigital Audio Signals Digital Control SignalUsing the Guide Button to Display ChannelView and Menus Copy-Protected Material NetCommand Controlled RecordingsRecord To Setup Time-Delayed RecordingTrack List Screen Cancel Current RecordingsRecord List Screen Disc SearchCanceling a Current Peer-to-Peer Connection NetCommand Controlled Peer-to-Peer ConnectionsWhat is a Peer-to-Peer Connection? Setting up a Peer-to-Peer ConnectionDirect VCR Recording Direct VCR Recording from an Antenna or Cable SourceRestrictions for Traditional VCRs For MP3 or WMA Audio Playback MediaCommand and Media Card PlaybackMedia Card Slots Inserting a media cardMedia Command and Media Card Playback Important Notes TV Menu Screen Operations Main Menu Choices Setup Menu Advanced Convergence Reset Factory Defaults MenuNetCommand Menu Antenna Menu SQV SuperQuickView Manual Setting the ClockTimer On/Off Time MenuDigital Captions Captions MenuCaptions Menu Analog CaptionsOpacity Font FontsSize ColorChip Start Time and V-Chip Stop Time Chip Lock MenuChip EntryChip Signal Information Content CategoriesTV Ratings Front Button Lock Lock By TimeAudioVideo AudioVideo MenuDigital Only Audio Settings Setting DescriptionsAnalog and Digital Audio Setting Analog Only Audio SettingsVideo Settings Chapter DVD Definitions Format SignalsDisplay Formats Format DefinitionsOriginal Signal PIP small PIP/POP off Operation of PIP and POPPOP PIP largeDigits Device Menu with Net CommandCH up/down VOL up/downWhen an Ieee 1394 Device is Viewed or Played Appendix a Bypassing the V-Chip Lock Bypassing the V-Chip LockBypassing Front Button Lock This page intentionally blank Input Levels and Timing with Component Video Signals Appendix B High Definition Input Connection CompatibilityComponent-1 and Component-2 Inputs Programming the Remote to Control NetCommand A/V Products Appendix CRemote Control Programming CodesDVD Players Appendix C Remote Control Programming CodesMitsubishi CD Players Not all functions for all models Cable Boxes and Satellite ReceiversReceivers Mitsubishi A/V ReceiversDigital Ieee 1394 Device Appendix D On Screen Information DisplaysAnalog Program Digital ProgramCheckbox Name Appendix E NetCommand Specialized Device KeysAppendix F Cleaning and Service Diamond Shield installation Diamond Shield RemovalFor additional assistance, call 800 Appendix H Cabinet Separation for Model WS-65815 For Mitsubishi Dealers and Service Personnel OnlyProblem Possible Solution TroubleshootingTroubleshooting Troubleshooting Troubleshooting Additional Information Demo ModeLicensing Information Index Menu 58 Mitsubishi Projection Television Limited Warranty Mitsubishi Projection TV Limited WarrantyMitsubishi TV Software Mitsubishi Digital Electronics America, Inc 871D406A10

WS-55815, WS-65815 specifications

The Mitsubishi Electronics WS-65815 and WS-55815 are high-quality rear-projection televisions that gained popularity in the early 2000s for their impressive display performance and advanced features. These models were designed to provide an immersive viewing experience, highlighting Mitsubishi's commitment to innovation in the home entertainment market.

One of the standout features of the WS-65815 and WS-55815 is their large screen sizes. The WS-65815 offers a massive 65-inch display, while the WS-55815 comes in at 55 inches. Both models utilize a DLP (Digital Light Processing) technology that delivers exceptional picture quality with vibrant colors and sharp details. DLP technology also contributes to deeper blacks and a higher contrast ratio, enhancing the overall visual experience.

Mitsubishi incorporated a 16:9 aspect ratio in both models, which is ideal for watching widescreen content, such as movies and sports events. The advanced color wheel in these televisions enhances the saturation and chromatic accuracy of the images displayed. Additionally, both models support 1080p resolution, making them compatible with high-definition broadcasts and Blu-ray Disc viewing, ensuring users can enjoy stunning picture clarity.

Another key characteristic of the WS-65815 and WS-55815 is their integrated video processing technology. The units feature a built-in 3D Y/C digital comb filter that significantly improves image quality by reducing artifacts and enhancing detail resolution. The televisions also offer multiple input options, including HDMI and component video, allowing users to connect various devices such as gaming consoles, cable boxes, and DVD players seamlessly.

The design of both models is characterized by a sleek cabinet finish, which allows them to blend seamlessly into modern home décor. Furthermore, the televisions are equipped with a user-friendly remote control with programmable features, enabling easy navigation through channels, inputs, and settings.

In summary, the Mitsubishi Electronics WS-65815 and WS-55815 rear-projection televisions stood out for their impressive screen size, advanced DLP technology, and rich, immersive picture quality. These models remain noteworthy examples of Mitsubishi’s innovation in television technology, making them desirable among enthusiasts even in today’s evolving market.
Top Page Image Contents