Mitsubishi Electronics WS-55815 manual Appendix H Cabinet Separation for Model WS-65815

Page 89

Appendix H: Cabinet Separation for Model WS-65815

For Mitsubishi Dealers and Service Personnel Only

The Mitsubishi TV model WS-65815 projection television cabinet has been assembled in two pieces. These pieces may be separated to allow for easier delivery and setup. The instructions below show how to safely separate and reattach the cabinet.

This projection television weighs over 249 pounds and has many sensitive components. This dismantling procedure should be done by authorized Mitsubishi Dealers or Service Personnel ONLY.

The following operations should be performed by two people:

3Front Glossy Panel

2Lower Bracket (Screw)

1 Speaker Grille

1.Remove Speaker Grille by pulling forward from left and right sides of TV.

2.Remove Front Glossy Panel screws at lower brackets.

3.Slide Front Glossy Panel to right side approximately 1/2", then pull away from TV.

4.Remove the screws attaching Cabinet-Top and Cabinet-Bottom from the front boards.

6Plastic Cover (Screw)

5Connector (LF-ZF)

4Front Board (Screw)

5.Disconnect the connector (LF-ZF).

6.Remove the decorative Plastic Cover on each side of the cabinet. Remove the exposed Screw on each side.

7.Secure the Cabinet-Bottom from moving, then slide forward the Cabinet-Top (may require some added force).

Carefully lift the Cabinet-Top straight up until the interlock Tabs are clear from Cabinet-Bottom.

8.Carefully place lower rear surface of Cabinet-Top on floor.

9.Once you have moved and positioned

the Cabinet-Bottom to its desired location, reverse the procedure and mount the Cabinet-Top on the Cabinet-Bottom . Be sure to align the Brackets properly. KEEP FINGERS CLEAR OF ALL

Cabinet-Top

7

2" Approximately.

Bracket

(Apply force here)

If needed.

JOINTS! Replace the Screws and decorative Plastic Covers that were removed in step 6. Rejoin the connectors per step 5. Replace the screws per step 4. Reinstall the Glossy Panel and Screws per step 2. Reinstall the Speaker Grille per step 1.

Cabinet-Top

Interlock Tabs

8 Cabinet-Top

Lower Rear Surface

Cabinet-Bottom

89

Page 88 Page 90
Image 89
Page 88 Page 90
Contents Projection Television Owner’s Guide Risk of Electric Shock Contents Accessories CleaningPower Source Power-Cord ProtectionDamage Requiring Service Power LinesReplacement Parts Safety CheckMitsubishi Digital Electronics America, Inc Our ThanksTelevision Overview ChapterSpecial Features TV AccessoriesFront Control Panel Front Control Panel, Multimedia AccessMultimedia Access Digital Audio Output Back PanelIEEE-1394 Input/Output CableCARD Slot IR Output-NetCommandHdmi or DVI Devices DVI Analog AudioSide bar images Letterbox top/bottom black barsNews and stock-market report bars Shopping channel logos & pricing displaysConnecting Device Audio and Video Outputs to TV Inputs Connecting External Devices & NetCommand SetupCable Box compatible with PIP/POP Connecting a Wall Outlet Cable or Cable BoxSeparate UHF and VHF Antennas Single AntennaFor antennas with twin flat lead For antennas with coaxial leadRed VCR to Antenna or Wall Outlet CableVCR to a Cable Box Connecting VCR Video and Audio to a Cable BoxSatellite Receiver or Other Device with S-Video Receiver or Stereo SystemDVI Device Connecting a DVD Player with Component Video or DVI DeviceDVD Player with Component Video External DTV Receiver with Component Video Hdmi DeviceIR Emitter NetCommand Connecting the IR Emitter NetCommandPin Style vs -Pin Style Connecting Ieee 1394 DevicesConnection Styles Ieee 1394 Device Connection StylesDirect Device-To-Device Style Hub Connection StyleCableCARD Technology Using a CableCARDCableCARD Definition and Initial Screen Display Connecting Helpful Hints NetCommand Setup and Editing Device NetCommand Pre-Memorized DevicesNetCommand On-Screen Buttons Following Remote Control Functions OverviewSleep Timer Remote Control FunctionsOperation, Care, Sleep TimerCare Operation3D Graphical Menu System Remote Control ButtonsNetCommand Information Screen NetCommand Initial SetupDevice Setup Screen Welcome ScreenFinish Screen Review ScreenReceiver Inputs Edit NetCommand, Adding an A/V ReceiverReceiver Screen Receiver Learn Screen Receiver Input Learn ScreenMonitor Out to AVR Screen Name ScreenEdit NetCommand Edit NetCommand, Adding DevicesDevice Screen Add ScreenDevice Advanced Learn Screen Device Learn ScreenVCR for Recordings Screen Connection for Device ScreenRF Connection for Cable Screen IR Code for Device ScreenDelete Screen Change ScreenDevice Selection Menu Device Menu Using the Device Menu Button to Display MenusIeee 1394 Devices and NetCommand Controlled Recordings Adding Ieee 1394 Devices Automatically Adding Ieee 1394 Devices AutomaticallyNew 1394 Device Screen Name for 1394 Device ScreenConnection Screen Ieee 1394 Device Type ScreenDigital Audio Signals Digital Video SignalsDigital Control Signal Ieee 1394 Devices CompatibilityUsing the Guide Button to Display ChannelView and Menus Record To Setup NetCommand Controlled RecordingsTime-Delayed Recording Copy-Protected MaterialRecord List Screen Cancel Current RecordingsDisc Search Track List ScreenWhat is a Peer-to-Peer Connection? NetCommand Controlled Peer-to-Peer ConnectionsSetting up a Peer-to-Peer Connection Canceling a Current Peer-to-Peer ConnectionRestrictions for Traditional VCRs Direct VCR RecordingDirect VCR Recording from an Antenna or Cable Source Media Card Slots MediaCommand and Media Card PlaybackInserting a media card For MP3 or WMA Audio PlaybackMedia Command and Media Card Playback Important Notes TV Menu Screen Operations Main Menu Choices Setup Menu Advanced Convergence Reset Factory Defaults MenuNetCommand Menu Antenna Menu SQV SuperQuickView Timer On/Off Setting the ClockTime Menu ManualCaptions Menu Captions MenuAnalog Captions Digital CaptionsSize FontsColor Opacity FontChip Chip Lock MenuEntry Chip Start Time and V-Chip Stop TimeTV Ratings Chip Signal InformationContent Categories Front Button Lock Lock By TimeAudioVideo AudioVideo MenuAnalog and Digital Audio Setting Setting DescriptionsAnalog Only Audio Settings Digital Only Audio SettingsVideo Settings Chapter Display Formats Format SignalsFormat Definitions DVD DefinitionsOriginal Signal POP Operation of PIP and POPPIP large PIP small PIP/POP offCH up/down Device Menu with Net CommandVOL up/down DigitsWhen an Ieee 1394 Device is Viewed or Played Bypassing Front Button Lock Appendix a Bypassing the V-Chip LockBypassing the V-Chip Lock This page intentionally blank Component-1 and Component-2 Inputs Input Levels and Timing with Component Video SignalsAppendix B High Definition Input Connection Compatibility Programming the Remote to Control NetCommand A/V Products Appendix CRemote Control Programming CodesDVD Players Appendix C Remote Control Programming CodesReceivers Cable Boxes and Satellite ReceiversMitsubishi A/V Receivers Mitsubishi CD Players Not all functions for all modelsAnalog Program Appendix D On Screen Information DisplaysDigital Program Digital Ieee 1394 DeviceCheckbox Name Appendix E NetCommand Specialized Device KeysAppendix F Cleaning and Service For additional assistance, call 800 Diamond Shield installationDiamond Shield Removal Appendix H Cabinet Separation for Model WS-65815 For Mitsubishi Dealers and Service Personnel OnlyProblem Possible Solution TroubleshootingTroubleshooting Troubleshooting Troubleshooting Additional Information Demo ModeLicensing Information Index Menu 58 Mitsubishi Projection Television Limited Warranty Mitsubishi Projection TV Limited WarrantyMitsubishi TV Software Mitsubishi Digital Electronics America, Inc 871D406A10

WS-55815, WS-65815 specifications

The Mitsubishi Electronics WS-65815 and WS-55815 are high-quality rear-projection televisions that gained popularity in the early 2000s for their impressive display performance and advanced features. These models were designed to provide an immersive viewing experience, highlighting Mitsubishi's commitment to innovation in the home entertainment market.

One of the standout features of the WS-65815 and WS-55815 is their large screen sizes. The WS-65815 offers a massive 65-inch display, while the WS-55815 comes in at 55 inches. Both models utilize a DLP (Digital Light Processing) technology that delivers exceptional picture quality with vibrant colors and sharp details. DLP technology also contributes to deeper blacks and a higher contrast ratio, enhancing the overall visual experience.

Mitsubishi incorporated a 16:9 aspect ratio in both models, which is ideal for watching widescreen content, such as movies and sports events. The advanced color wheel in these televisions enhances the saturation and chromatic accuracy of the images displayed. Additionally, both models support 1080p resolution, making them compatible with high-definition broadcasts and Blu-ray Disc viewing, ensuring users can enjoy stunning picture clarity.

Another key characteristic of the WS-65815 and WS-55815 is their integrated video processing technology. The units feature a built-in 3D Y/C digital comb filter that significantly improves image quality by reducing artifacts and enhancing detail resolution. The televisions also offer multiple input options, including HDMI and component video, allowing users to connect various devices such as gaming consoles, cable boxes, and DVD players seamlessly.

The design of both models is characterized by a sleek cabinet finish, which allows them to blend seamlessly into modern home décor. Furthermore, the televisions are equipped with a user-friendly remote control with programmable features, enabling easy navigation through channels, inputs, and settings.

In summary, the Mitsubishi Electronics WS-65815 and WS-55815 rear-projection televisions stood out for their impressive screen size, advanced DLP technology, and rich, immersive picture quality. These models remain noteworthy examples of Mitsubishi’s innovation in television technology, making them desirable among enthusiasts even in today’s evolving market.
Top Page Image Contents