Preparating your projector
Checking accessories
The following accessories are provided with this projector. Check to be sure that all of the accessories are packed in the package.
Power supply parts
Power cord (two) (42.50115.021, 42.50122.011)
Remote control parts
Remote control | R03 | |
battery (two) | ||
(45.80H01.002) | ||
|
Cables |
| Others | |
|
| • Lens cap (Attached to the | |
Mini | projector) (51.80H05.001) | ||
| • User manual (36.81F01.001) | ||
|
| ||
|
| • Quick Start up (36.81F02.001) | |
|
| • Remote control | |
| protection sticker (two) | ||
DVI | (35.80H03.001) | ||
| |||
| • Cushion (See page 11.) | ||
Mini |
| ||
(42.86603.001) |
| ||
conversion cable (42.80H04.001) |
| ||
|
|
• Used for adjustment by service person.
IMPORTANT:
• The attached power cords are to be used exclusively for this product. Never use them for other products.
| Inserting the batteries into the remote |
| control |
1 | 1. Remove the rear lid of the remote control. |
2. Check the polarity (+), | |
3 | correctly, inserting their |
| • If the battery is inserted from the (+) side first, |
| inserting the |
2 | end hits on the battery side. If the battery is forced to |
insert in this way, the outer label of the battery may | |
| get ripped and it may cause a |
| heating. |
| 3. Attach the rear lid. |
Important:
•Use two
•Replace the two batteries with new ones when the remote control is slow to operate.
Caution:
•If the batteries are treated incorrectly, they may cause fire or other contamination due to leakage of the liquid, heating, or they may burst. (Read the cautions indicated on the battery, too.)
•Do not use a new battery with an old one.
•Load batteries in the correct position.
•Do not heat, take apart, or throw batteries into fire.
•Do not try to recharge batteries. Do not use rechargeable batteries.
•If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.