PC analog RGB input
Use to input video signals (analog RGB) of a personal computer.
10
(Pin assignment of Mini
PIN NO. | SPEC | PIN NO. | SPEC |
1 | R(RED) / Cr | 9 | - |
2 | G(GREEN) / Y | 10 | GROUND |
3 | B(BLUE) / Cb | 11 | GROUND |
4 | GROUND | 12 | - |
5 | GROUND | 13 | HD/CS |
6 | GROUND | 14 | VD |
7 | GROUND | 15 | - |
8 | GROUND |
|
|
|
|
|
|
RS-232C input
•Connect here when you control this Projector with a personal computer using PCGC (personal computer graphic controller) or with a remote controller using SpacePointer function.
•The Pin assignment is DTE (Data Terminal Equipment) type.
•Please use
5 1
6
15 11
1 5
6 9
(Pin assignment of
PIN NO. | CODE | NAME | I/O | NOTE |
1 | CD | Carrier Detect | INPUT | not connected |
|
|
|
|
|
2 | RD | Receive Data(RXD) | INPUT | connected to inner circuit |
|
|
|
|
|
3 | SD | Send Data(TXD) | OUTPUT | connected to inner circuit |
|
|
|
|
|
4 | ER | Equipment Ready(DTR) | OUTPUT | connected to inner circuit |
|
|
|
|
|
5 | SG | Signal Ground |
| connected to inner circuit |
6 | DR | Data Set Ready(DSR) | OUTPUT | connected to inner circuit |
|
|
|
|
|
7 | RS | Request to Send(RTS) | OUTPUT | connected to inner circuit |
|
|
|
|
|
8 | CS | Clear to Send(CTS) | INPUT | connected to inner circuit |
|
|
|
|
|
9 | CI | Ring Indicator | INPUT | not connected |
Bottom side
foot adjustment
Use to adjust the angle of the projector.
See page 15.
Note: Be sure to retract them when packing up the projector.
ventilation slots
Used to protect the projector from overheating.
See page 47.
ventilation air filter
This prevents dust from entering inside the projector. See page 47.
11