Mitsubishi Electronics X100 manual To operate projector power on, Auto button

Page 22

To operate projector power ON

Numbers 1~10 correspond to the instruction numbers below.

1,10

Left side

PC-1 IN	PC-AUDIO

PC-1 OUT

PC-2 IN
RS-232C	LINE-OUT

INPUT 1 INPUT 2

MAIN

AUDIO

L

R

AC IN

VIDEO

S-VIDEO

4

LAMP TEMP	CARD1	CARD2
FREEZE	EXPAND	FINE	FOCUS
SOURCE /CAPTURE	/PinP MENU	FINE	/ZOOM AUTO

ENTER

3,8,9 4

7

6 5 AUTO button

1.Put the projector into standby mode by pressing the main power switch. The POWER indicator lights up red.

2.Turn on the equipment connected to the projector.

3.Turn the projector on by pressing the POWER button. The light source lamp starts warming up, eventually turn on.

LAMP TEMP

FREEZE SOURCE /CAPTURE

condition	indicator	LAMP	POWER
	stand-by	-	red
when light source lamp is on		green	green

when light source lamp does not light up		-	red

Important:

•A darkened image may be seen right after pressing the POWER button due to warming up of this projector. When warming up, no other commands can be accepted.

•When the lamp indicator is blinking red, the service life of the lamp is about to end. Replace the lamp. See page 48.

•The picture might not be of optimum performance in extreme hot or cold conditions. (The projec- tor is not malfunctioning.)

22

Image 22

Contents X100 Page Compliance Notice of FCC Contents Important safeguards Important safeguards If you break or drop the cabinet Never remove the cabinetDo not modify this equipment Do not face a lens to the sunOverview of the projector FINE, ADJUST, FOCUS/ZOOM and Auto buttons Left side Bottom side Overview of the remote control Battery installation Preparing the projector for operation Orientation of the projectorScreen Adjusting the angle of projectionGetting ready for projection Ground terminalBasic connections AT VGACables and adapters Order of turning on / offProjector + IBM PC or IBM PC compatibles DOS Basic connections continueDesktop computer Projector + Macintosh Power BookWhen outputting to both a PC monitor and the projector DesktopDesktop computer display connector Projector + NEC PC-98 and Epson PC seriesProjector + AV equipment To operate projector power on Auto buttonTurning off the projector VIDEO1 VIDEO2 RGB1Menu operation Menu layersBasic operation Example Brightness adjustment 3 2,4Menu operation continue Normal menuGamma Correction menu Enhanced menu ReverseSuper Pointer menu Audio menuReceive Auto Power OFF Option menuUser Presets menu Simple way of adjustmentAdvanced feature for presentation Cursor operationExpand Super impose Picture in Picture Emergency capture from projector source Using the PC-CARDSetting up / replacing the PC-CARD Play backPage Advanced feature with PC EnvironmentPCV PC Card Viewer Installation of softwareCommand reference Starting up PC Card ViewerReturn button Delay time button Capture button Recording the imageEditing the presentation Pcgc Personal Computer Graphic Control ConnectionIndicators Indicator and main menu control windowPower button and indicator Starting up PcgcRemote control window Sub menu control windowOperation of PC by remote control SpacePointerEnable/Disable Setting of SpacePointerUninstallation of software Port selectionCleaning the projector and the ventilation slots MaintenanceCleaning the air-filter Cleaning the lensReplacement of a light source lamp Purchase of the light source lamp Life of the lampIndicators / TEMP, LAMP, Power Indicator Shows Condition Possible SolutionsTroubleshooting Problems Cause Possible SolutionsImage Specifications Rated input LCD panelsAccessories Replacement parts listWhat’s included in the box Mitsubishi Electronics AMERICA, INC