Mitsubishi Electronics X100 manual Image

Page 52

	PROBLEMS	CAUSE	POSSIBLE SOLUTIONS
	The image	• When you see the stationary image for a long time, it may remain on the screen if
	remains blurred.	you change the image. It is not a breakdown. The blurred image will disappear in a
		few minutes.

	Red, blue or green	• It is normal.
	dots are viewed on
	the text of image.

	The image is	• The cable for connection with other	• Plug the connecting cable securely into the
	distorted on the	equipment is not plugged securely	terminal. See pages 17-21.
	screen and	into the terminal.
	screen and	• The projector is installed too close to	• Install the projector far away from other
	noise is heard.	• The projector is installed too close to	• Install the projector far away from other
		other equipment.	equipment.

	No sound is	• Volume is not turned up.	• Turn up the volume.
	No sound is	• Mute function on PCGC is on.	• Cancel the mute function. See page 30.
	heard.	• Connection to other equipment is not	• Check connections.
		• Connection to other equipment is not	• Check connections.
		made correctly.	See page 21.

	Nothing is	• The PC monitor is not turned on.	• Turn on the monitor.
	displayed on
	the PC monitor.

	Warm air comes out	• This is typical of the LCD projector.
	of the exhaust vents.

	Adjustments cannot	• The operation is incorrectly made due	• Reset the mode and try again.
	be made.	to noise or interference.

52

Image 52

Contents X100 Page Compliance Notice of FCC Contents Important safeguards Important safeguards Never remove the cabinet Do not modify this equipmentIf you break or drop the cabinet Do not face a lens to the sunOverview of the projector FINE, ADJUST, FOCUS/ZOOM and Auto buttons Left side Bottom side Overview of the remote control Battery installation Preparing the projector for operation Orientation of the projectorAdjusting the angle of projection Getting ready for projectionScreen Ground terminalBasic connections AT VGACables and adapters Order of turning on / offProjector + IBM PC or IBM PC compatibles DOS Basic connections continueDesktop computer Power Book When outputting to both a PC monitor and the projectorProjector + Macintosh DesktopDesktop computer display connector Projector + NEC PC-98 and Epson PC seriesProjector + AV equipment To operate projector power on Auto buttonTurning off the projector VIDEO1 VIDEO2 RGB1Menu operation Menu layersBasic operation Example Brightness adjustment 3 2,4Menu operation continue Normal menuGamma Correction menu Enhanced menu ReverseSuper Pointer menu Audio menuReceive Auto Power OFF Option menuUser Presets menu Simple way of adjustmentAdvanced feature for presentation Cursor operationExpand Super impose Picture in Picture Using the PC-CARD Setting up / replacing the PC-CARDEmergency capture from projector source Play backPage Advanced feature with PC EnvironmentInstallation of software Command referencePCV PC Card Viewer Starting up PC Card ViewerReturn button Delay time button Capture button Recording the imageEditing the presentation Pcgc Personal Computer Graphic Control ConnectionIndicator and main menu control window Power button and indicatorIndicators Starting up PcgcRemote control window Sub menu control windowOperation of PC by remote control SpacePointerSetting of SpacePointer Uninstallation of softwareEnable/Disable Port selectionMaintenance Cleaning the air-filterCleaning the projector and the ventilation slots Cleaning the lensReplacement of a light source lamp Purchase of the light source lamp Life of the lampIndicators / TEMP, LAMP, Power Indicator Shows Condition Possible SolutionsTroubleshooting Problems Cause Possible SolutionsImage Specifications Rated input LCD panelsAccessories Replacement parts listWhat’s included in the box Mitsubishi Electronics AMERICA, INC