OFA Kam 6 Hybrid Owners Manual.fm Page 21 Wednesday, March 30, 2005 3:09 PM
SOLUTION: | Clear the device key as follows: | |
| 1. | Press and hold SET until |
|
| the Inner IR Segments |
|
| blink twice, then release. |
| 2. | Enter 9 9 2. |
| 3. | Press the device key to be |
|
| cleared twice. |
| 4. | Repeat the Search For |
|
| Your Code method. |
|
| |
PROBLEM: | The remote changes TV | |
| channels when entered with | |
| the digit keys but does not | |
| operate the channel up or | |
| down correctly (channels are | |
| skipped). | |
SOLUTION: | You will need to “Auto | |
| program” the channels on | |
| your TV. Consult your TVs | |
| owners manual for this | |
| feature. | |
|
| |
PROBLEM: | No remote control of volume. | |
SOLUTION: | See Changing Volume Lock on | |
| page page 16 to lock/unlock | |
| volume. | |
|
| |
PROBLEM: | If the above does not work. | |
SOLUTION: | Please contact us in any of the | |
| following ways: | |
| • | Please visit |
|
| www.oneforall.com |
| • | If the above website is not |
|
| able to provide you with |
|
| the information you |
|
| need, please email us at |
|
| ofasupport@ueic.com |
|
| and refer to |
|
| “Troubleshooting” |
| • | Customer Support: |
|
| (330) |
|
| Mon – Fri from |
|
| 9AM to 5:30 PM EST |
|
|
|
OWNER’S MANUAL
FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide a reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiated radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet or a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
MANUFACTURER’S CODES
SETUP CODES FOR AUDIO AMP/TUNERS
ADC | 0531 |
|
|
Adcom | 0616 |
|
|
Aiwa | 1405, 0158, 0189, 1388, |
| 0121, 0405, 1641 |
|
|
Akai | 1512, 0224 |
|
|
Alco | 1390 |
|
|
FCC Compliance 21