No display when

OFA Kam 6 Hybrid Owners Manual.fm Page 20 Wednesday, March 30, 2005 3:09 PM

OFA Kameleon™ 6-Device Hybrid Remote

PROBLEM:	No display when
	programming.
SOLUTION:	Display has turned off due to
	inactivity. Start programming
	again and do not pause while
	performing instructions.

PROBLEM:	During programming, the two
	inner IR segments display a
	long flash.
SOLUTION:	An invalid entry has occurred.
	Check the keys to be pressed
	and start programming again.

PROBLEM:	IR sent animation is displayed
	when you press a key, but
	home entertainment device
	does not respond.
SOLUTION:	Make sure the remote control
	is aimed at your home
	entertainment device and is
	not farther than15 feet away.

PROBLEM:	The unit does not control
	home entertainment devices
	or commands are not working
	properly.
SOLUTION:	Try all listed codes for the
	device brands being set up.
	Make sure they can be
	operated with an infrared
	remote control.

PROBLEM:	Tried Searching For Your Code
	method and still could not
	find a working code.
SOLUTION:	Perform Restoring Factory
	Default Settings on page 17.
	Then repeat Searching For
	Your Code on page 10.

PROBLEM:	Cannot program a macro onto
	M1, POWER or other keys.

SOLUTION:	Make sure the total number of
	key presses being
	programmed is less than 15
	and that you are not trying to
	program a macro on an
	invalid key (Device keys, Set
	Key and Fav key).

PROBLEM:	Power macro does not execute.
SOLUTION:	Make sure to press and hold
	the POWER for at least three
	seconds to initiate Power
	Macro.

PROBLEM:	Changing channels does not
	work properly.
SOLUTION:	If original remote control
	required pressing ENTER or OK
	to change channels, press
	ENTER or OK on the remote
	control after entering the
	channel number.

PROBLEM:	During learning, Inner IR
	Segments display a long blink
	after pressing and holding key
	to be learned.
SOLUTION:	Memory is full or a bad
	capture has occurred. Avoid
	high-ambient light sources,
	such as direct daylight and
	fluorescent bulbs. Try
	readjusting positions of
	remote controls before
	performing the procedure
	again.

PROBLEM:	Tried Search For Your Code
	method and still could not
	find a working code.

20 Troubleshooting