One for All URC-6690 Using Learning, VCR/PVR, DVD or CBL/SAT once, Learning Precautions

OFA Kam 6 Hybrid Owners Manual.fm Page 13 Wednesday, March 30, 2005 3:09 PM

3.To stop scanning channels at any time, press any key once.

PROGRAMMING FAVORITE CHANNEL SCAN

In the TV, VCR/PVR, DVD and CBL/SAT modes, you can store a list of up to 10 favorite channels, in any order, that will be immediately scanned when FAV is pressed (see Using Channel Scan).

NOTE: Only channels of one mode can be stored for Favorite Channel Scan.

1.On the remote control, press TV,

VCR/PVR, DVD or CBL/SAT once.

2.Press and hold SET until the two Inner IR segments flash twice. The current mode key will blink on and off during programming.

3.Enter 9 9 6. The Inner IR Animation will blink twice.

4.Use the keypad to enter a favorite channel number (e.g., 0 3 1). Then press SET once.

NOTE: If the original remote control required pressing an Enter key to change the channel, also press the Enter key after the channel number (e.g., 0 3 1 Enter).

5.If desired, repeat step 4 (in this section) for each favorite channel to be stored, up to a total of 10 channels.

NOTE: If you try entering more than 10 channels, the remote control will automatically exit programming.

6.To exit programming, press and hold SET for 3 seconds. The Inner IR Animation will blink twice.

OWNER’S MANUAL

USING LEARNING

The OFA Kameleon™ 6-Device Hybrid Remote (URC-6690) includes a Learning feature so you can add functions that are unique to your home entertainment devices (e.g., DVD EJECT). However, there are some considerations.

LEARNING PRECAUTIONS

•Your original remote controls must be in working order for learning to work properly.

•Learned keys are mode specific, so each one can store a unique function for each mode.

•Learned keys can be used in macros (see Using Macros on page 11).

•Do not use the following keys for learning: Device Keys, SETUP, FAV, or Record (•) Key.

•Learning capacity is approximately 50 to 70 keys, depending on the code being learned.

•If both learned and keymoved functions are assigned to the same key, the last programmed function is stored.

•A learned function cannot be used as a source for Keymover (see Using Keymover on page 15).

•Certain device codes are not learnable including multi-frequency types, some high frequency ones, and other unusual formats.

•For optimum learning, avoid high levels of ambient light such as natural sunlight or energy-efficient fluorescent lights.

Programming Favorite Channel Scan 13