Wacom DTK-2200 user manual Configuring Cintiq for Handedness, Using the Grip PEN

ContentsIndex

24

CONFIGURING CINTIQ FOR HANDEDNESS

During the installation process, you were prompted to choose a default configuration for Cintiq based on whether you are right- or left-handed. The configuration you chose was used to determine the default settings for the ExpressKeys and Touch Strips.

However, you can use the Wacom Tablet control panel to easily reconfigure Cintiq for left- or right-handed users at any time. The ExpressKey and Touch Strip settings are automatically reconfigured when you change the handedness setting.

To reconfigure for left- or right-handed users:

1.Launch the Wacom Tablet control panel by pressing the center hardware control button. Click OPTIONS....

2.Choose the appropriate setting for your preferred handedness.

3.Click OK. The existing ExpressKey and Touch Strip settings are swapped (or flipped) between left and right.

Notes:

The hardware control buttons are not affected when you change the handedness setting.

Likewise, changing the handedness setting does not affect the ExpressKeys used to control the LCD settings when in LCD settings (OSD) mode.

This procedure does not affect the default orientation. At the system log on and user switching screens, the pen display uses the default configuration you chose during the install process. To change the default configuration, you must re-install the Wacom driver.

USING THE GRIP PEN

The cordless, battery-free pen senses the amount of pressure and tilt you apply to the tip. There are four basic techniques for using the pen: pointing, clicking, double-clicking, and dragging. If you are unfamiliar with using the pen, see the following pages.

Holding the pen

Positioning

Clicking

Dragging

Using the side switch

Working with pressure sensitivity

Drawing with tilt

Erasing

ContentsIndex

24