EverFocus EDR-1640, EDR-920 manual System Menu, SAVE/LOAD Configuration

3.12 SYSTEM MENU

SYSTEM SETUP MENU
SYSTEM VERSION		V1.22
SYSTEM VIDEO FORMAT		PAL
LOAD/SAVE CONFIGURATION
		NO
UPDATE SYSTEM SOFTWARE		NO
LANGUAGE		ENGLISH
QUICK PLAY	ON 10 MINUTES AGO
SYSTEM PASSWORD ENABLE		NO
	PASSWORD	RIGHTS
LEVEL-3	*************	ADMINISTRATOR
LEVEL-2	*************	OPERATOR
LEVEL-1	*************	GENERAL

Define the following settings in the SYSTEM menu:

(1)SYSTEM VERSION: Display of the installed firmware version.

(2)SYSTEM VIDEO FORMAT: Display of the detected video system PAL or NTSC. The EDR automatically detects the video system upon system startup.

ATTENTION: Auto detection checks video input 1 upon system startup. Therefore, it is compulsory to start the DVR with video signal connected to channel 1. Otherwise, default setting NTSC is loaded!

(3) SAVE/LOAD CONFIGURATION:

Selecting YES opens a sub menu showing the following items (use the JOG for selection):

CANCEL: Return to system menu

DEFAULT: Load default setting after security request YES/NO

ATTENTION: The network settings remain stored despite loading default setting! SAVE: Save the current configuration to CF card / USB stick. LOAD: Load a configuration from CF card / USB stick.

(4)UPDATE SYSTEM SOFTWARE: DVR update with latest firmware version through USB-stick or CF card. At first, place the CF card or the USB stick into the respective interface.

YES: After confirmation with SELECT, the firmware update is run. Update is carried out in 3 phases (display at bottom screen margin) and can take up to 5 minutes.

ATTENTION: 1. Before starting the update, stop the recording process.

2.Do not switch the DVR off while update is run.

3.Do not remove CF card or USB stick while update is run. NO: Cancel, return to SYSTEM menu

53