EverFocus EMV200 user manual Rear Panel, Rear panel, GPS Antenna Connect to the GPS antenna

1)SD Card Slot: Slot to insert SD card.

2)IR Receiver: Receiver for IR remote control.

3)Alarm Input(2), Alarm Output(1) & RS232:

Alarm Input (2) - Connect up to 2 alarm inputs, selectable between N.O./N.C. contacts.

Alarm Output (1) - N.C or N.O type alarm out (form “C”).

RS232 - Connect to RS232/RS485 compatible device.

4)Power LED: This LED ON indicates Power on.

5)Network Connector: RJ-45 network connection 10/100Mbps Ethernet. There are two LEDs on the LAN jack; Green LED means network is connected, amber LED flickers when data is being exchanged.

6)Philips mounted/Pin-torx: Use Philips screw for an easier mounting to prevent over-tightening. Use Pin- torx for a safe installation to prevent cam-out. A screwdriver is included for Pin-torx.

REAR PANEL

During initial setup you will be connecting your DVR to multiple input and output devices. This is done through the

rear panel.

Figure 1-2 Rear Panel

○1 GPS Antenna: Connect to the GPS antenna.

○2 Power Input and Switched Ignition: 1 pin is reserved for power input; connect to 10V~36VDC power source. 1 pin is for ignition control; connect to the other vehicle devices to avoid excess power consumption at ignition.

4