Clover Electronics CDR0860 Installation and Connections, Camera Connection, Monitor Connection

MODEL: CDR1660 / CDR0860 / CDR0460 H.264 STAND-ALONE DVR USER MANUAL V 2.6

6. INSTALLATION AND CONNECTIONS

6.1. NOTE FOR INSTALLATION

Install the system according to the instructions described in this manual.

Avoid any area with high humidity or dust which can shorten lifetime of the system.

Choose a well ventilated area and keep minimum of 10” away from obstructions. Do not place the system near heat generation devices.

Avoid any area with movement as this can interfere with the internal Hard Drive.

Use a compatible input/output signal type of cameras and monitors.

Contact your dealer if you have any problems in regards to the installation of this system.

6.2. CAMERA CONNECTION

Connect the Cameras with the BNC Cables to the “CAMERA IN” ports on the rear panel of the DVR as shown in the below figure.

6.3. MONITOR CONNECTION

6.3.1. CONNECTION OF VGA MONITOR

Connect one end of the VGA Cable to the VGA port of the LCD monitor and the other end to the VGA port of the DVR as shown in the below diagram.

< Model: CDR0460 >

24