SVAT Electronics CLEARVU10 instruction manual Installation

SVAT ELECTRONICS

3.INSTALLATION

now you can see

THINGS TO CONSIDER BEFORE YOU INSTALL YOUR CAMERA

•The camera should be installed between 8 and 13ft above the area to be monitored.

•Ensure there are no obstructions in the camera’s view, to maximize viewing area.

•Ensure that the sunshade is positioned to avoid glare and position camera away from direct sunlight.

•Decide whether the camera will be wall-mounted or sit on a desk/table top. If wall mounting, use the mounting hardware in the package.

We recommend that the mounting bracket is secured using the included screws for all installations.

•This camera comes with 60ft of video/power wire. Please make sure that you mount the cameras no more than 60ft from the TV/monitor/

VCR/DVR.

•We recommend using a surge protected power bar to protect the cameras internal circuitry.

4.MOUNTING

1.Screw the mounting bracket into the camera’s mounting hole, turning it clockwise.

2.Mount the camera in the desired location no more than 60 feet from the TV/Monitor/VCR/DVR unless you have purchased additional wiring. You may wall mount or desk mount these cameras.

3.Adjust cameras to the desired viewing angles.

5.STEPBYSTEP

1.Plug the 4 PIN DIN female connection on the camera into the 4 PIN DIN male connection on the 60ft video/power wire.

2.Match the two arrows on top of both connecting cables.

3.Plug the camera’s power supply into the power jack located on the 60ft video/power wire.

4.Plug the camera’s power adapter into an AC outlet.

5.Connect the 60ft video/power wire’s male RCA plug to the VIDEO IN port of your TV/monitor/VCR/DVR.

6.If your VIDEO IN port is a BNC connection (common with DVR units), you will need to attach the BNC to RCA adapter before connecting the camera.

1

3

5

2

4

6

CLEARVU10 113