Operation Instruction, Menu Setup | SVAT Electronics CVDVR900

OPERATION INSTRUCTION

A. Menu Setup

While system is powered up, select [General Setting] to alter the system setup. The setup menu can be seen below, highlight the item for selection and then press [Enter] to confirm. (while system recording, not allow to change any setting for current channel)

GENERAL SETTINGS

Record Settings

Timer Record

Motion Detection

Alarm Record

Channels

Housings

Network

Language

Exit

A-1 General Parameter Setting:

Highlight and select "General Settings", then press [Enter] for this selection, the sub-menu will shown (as below), then select the desired area.

GENERAL SETTINGS

Date / Time: 2003-05-08-23:59:00 Saturday

Unit ID:

Location:

HDD Overwrite: Yes

System: PAL NTSC

Admin_pwd_modify Operate_pwd_modify

HDD Format

Restore Default Setting

Return

Date/ Time: Highlight and press [Enter] to confirm for change for date and time, range will apply following:

•YEAR: from 2000 to 2099, only change the last 2 digits (eg. "03" for Year 2003);

•MONTH: Range 01 ~12;

•DAY: Range 01~31;

•HOUR: Range 00~23;

•MINUTE: Range 00~59;

•SECOND: Range 00~59;

After the [Return] key is pressed, the settings will be saved while power is on. However, the settings will not be saved when the system restarts.

Unit ID: Changing the ID from 000 to 999, this ID used for the login identification.

Location: Key in the address for the location of the unit.

HDD Overwrite: Select one of two options: ON and OFF. When ON is selected, this will allow recording continuously even if the hard disk space fulls up. The video will be recording into FIFO (First-In-First-Out) format. When OFF is selected, the recording function will stop once the HDD has filled up.

System: Select one of two options: "PAL" and "NTSC", then press [Enter] to confirm. NTSC is the standard for North American video systems while PAL is standard for European recording systems.

Admin_pwd_modify: Allows the you to change the administrator password, press[Enter] to enter this function. It will require you to key-in the new password twice to confirm the new password (this option only available with the administrator authorization level).

Operate_pwd_modify: Allows the you to change the operator password, press[Enter] to enter this function. Require the user to key-in the new password twice to confirm.

HDD Format: This will allow you to format the hard disk drive while non-recording status, while this option being selected, select with [START] and press [Enter] to confirm this function.

Restore Default Setting: Restore all the settings to the factory level settings. A confirmation option will appear to reconfirm system restore. A sample chart is shown on the next page.

Return: Go back to previous menu.