SVAT Electronics CVDVR900 user manual Housing Setting, Network Setting, Language Setting

Page 16

OPERATION INSTRUCTION continued

• Use the directional key to move small yellow block selection. When 4 points of yellow block are produced there will be q region wet up for the coverage setting area.

Time insert: "On, Off" are the 2 different status settings. Use the cursor to select and press [Enter] to confirm this function. While "On" selected, a system clock will be shown while recording.

A-7 Housing Setting:

Highlight and select Housings, then press [Enter]for the selection, the sub-menu will shown (as below), then select the required area.

GENERAL SETTINGS

Housing Settings

 

 

Record Settings

Channel

Protocol

BaudRate

No.

Timer Record

Motion Detection

1

pelco-d

1200

01

Alarm Record

2

pelco-p

2400

10

Channels

3

enkel

4800

25

Housings

4

ccr-20g

9600

63

Network

Return

 

 

 

Language

 

 

 

Exit

 

 

 

 

Protocol: Using the cursor to select and press [Enter]to confirm difference protocol (pelco-d/p/02-15 etc.);

BaudRate: Using the cursor to select and press [Enter] select difference rate at 1200/2400/4800/9600;

No: Using the cursor to select and press [Enter] select difference housing number at (01~63).

A-8 Network Setting:

Highlight and select Network, then press [Enter] for this selection, the sub-menu will be shown (as below), then select the required area.

GENERAL SETTINGS

Network Settings

 

Record Settings

IP Address:

029, 010, 001,100

Timer Record

Motion Detection

Subnet mask:

255,255,255,000

Alarm Record

Default gateway:

029,010,001,254

Channels

Transport protocol:

TCP/IP

Housings

Return

 

Network

 

Language

 

 

Exit

 

 

IP Address: Use the cursor to select and press [Enter]to enter the IP address.

Subnet mask: Use the cursor to select and press [Enter]to enter the subnet mask at current location.

Default Gateway: Use the cursor to select and press [Enter] select default gateway according to current IP address.

Transport protocol: Use the cursor to select and press [Enter] select.

A-9 Language Setting:

Make sure that English is the default setting.

Image 16
Contents Now you can see Installation Environment Installation GuidelineOther notices Product FUNCTIONS/ Features Front Panel and key definition LED Indicator status area Front PanelMenu Operation Playback functionFront Panel Other optionsMPEG4 Alarm connector pin definition Back Panel and connection outletRemote Control Remote Control Key Definition / FunctionOther options System Login System START-UP/SHUT DownSystem Start up System LogoffGeneral Parameter Setting Menu SetupOperation Instruction Example below is the record default setting Record Parameter SetupTimer Record Setting Conversion Table for Image Quality and Encoding RateMotion Detection Setting Alarm Record Setting Alarm RecordChannel Setting Network Setting Housing SettingLanguage Setting Info Menu 10ExitAll Record Alarm Record Alarm Log Operate LogChannel Status HDD StatusCompact Flash Card Upgrade Operation Instruction Renew setting Copy InformationRecording and Playback Instruction Technical Specification Data Adjustment for Picture Parameter and Sound LevelParameter adjustment IDE requirement AppendixPlayback DVR Hard disk with PC