Video setup

[Analogue Output]

Select an analogue setting based on the audio device that is connected through the analogue audio jack.

[LT/RT] - For the surround sound output through two speakers.

[Stereo] - For the stereo output. [Digital Audio]

6HOHFWDGLJLWDOVHWWLQJEDVHGRQWKHGLJLWDODPSOLÀHU receiver that is connected through the digital jack (coaxial/digital).

[Digital Output] - Select a type of digital output.

[All] - Support multi-channel audio formats.

[Off] - Disable digital output.

[PCM Only] - Downmix to two-channel audio format.

[LPCM Output] - Select the LPCM (Linear Pulse Code Modulation) output sampling rate. >N+=@ - For discs recorded at sampling

rate of 48 kHz.

>N+=@ - For discs recorded at sampling rate of 96 kHz.

Note

[LPCM Output] setting is only available if the [Digital Output] is set to [PCM Only].

The higher the sampling rate, the better the sound quality.

[Volume]

Set the default volume level when you play a disc.

1.Press OK.

2.Press to set the volume.

3.Press OKWRFRQÀUPDQGH[LW

[Sound Mode]

Select a preset sound effect to enhance the audio output.

[3D] - Select a virtual surround sound effect that is produced from the left and right audio channels.

[Movie Mode] - Select a sound effect for movies.

[Music Mode] - Select a sound effect for music.

[CD Upsampling]

For better sound quality in stereo mode, convert the music CD to a higher sampling rate.

[Off] - Turn off CD-upsampling.

>N+]@ - Convert to twice the original sampling rate.

>N+]@ - Convert to four times the original sampling rate.

	[Night Mode]	English
	Make loud sound level softer and soft sound level	English
	Make loud sound level softer and soft sound level
	louder so that you can watch the DVD movies at a
	low volume, without disturbing others.
	[On] - Enjoy quiet viewing at night.
	[Off] - Enjoy surround sound with a full
	dynamic range.

Note

Applicable only to Dolby Digital encoded DVDs.

	Press SETUP.
	» >*HQHUDO6HWXS@ menu is displayed.

2 Press to select [Video Setup], and then press to enter the submenu.

3Select an option, and then press OK.

Select a setting, and then press OK.

To return to the previous menu, press

BACK.

To exit the menu, press SETUP. [TV System]

Change this setting if the video does not appear correctly. By default, this setting matches the most common setting for TVs in your country.

[PAL] - For a PAL-system TV.

[Multi] - For TV that is compatible with both PAL and NTSC.

[NTSC] - For an NTSC-system TV. [TV Display]

Select a display format:

EN 13

Make loud sound level softer and soft sound level

Video setup

BACK.

 To exit the menu, press SETUP. [TV System]

To exit the menu, press SETUP. [TV System]