Philips SRU4105/27 owner manual Troubleshooting, Remote does not operate your product

Page 11

Troubleshooting

Remote does not operate your product

1.Select the mode for the product you want to control.

2.Program the remote with a new code.

3.Install new batteries in the remote. (You might have to reprogram your remote after installing new batteries.)

4.If these steps do not work, the remote might not be compatible with your product.

Remote does not operate some features of your product

1.Program remote with a new code.

2.If this does not work, your remote might not be able to operate all features of your product or the button names might be different than your product’s.

Indicator blinks after you program a product code

1.This means the remote did not accept the code.

2.Try to program the code again or try a different code.

For help with setup, please call: (919) 573-7854.

20

Limited Lifetime Warranty

The manufacturer warrants that this product shall be free from defects in material, workmanship and assembly, under normal use, in accordance with the specifications and warnings, for as long as you own this product. This warranty extends only to the original purchaser of the product, and is nontransferable. Defective products, together with the dated proof of purchase, must be returned to the place of purchase for repair or replacement. THERE ARE NO OTHER EXPRESS WARRANTIES. Incidental and consequential damages are disclaimed where permitted by law. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Made in China. Quality Assured in USA.

Ledgewood, NJ 07852

21

Image 11

Contents SRU4105/27 Introduction Table of ContentsREC, STOP, PAUSE, Play VCR controls Button FunctionsTV, VCR, DVD, CBL, SAT Indicates which UP, DOWN, LEFT, Right Navigation buttonsSetup Code Search Code Identification FeatureDirect Code Entry Code Search by Brand Adjusting the Delay Between Digits Setting FavoritesProgramming Combo Device Codes Tips On Learning Code LearningIR Transmitter Finder Learning CommandsMaster Clear Clearing CommandsTo ClearAll Learned Commands Undera Mode Master Clear To Clear All Learned Commands UnderAll ModesLimited Lifetime Warranty TroubleshootingRemote does not operate some features of your product Indicator blinks after you program a product codeIntroducción Tabla de contenidosFunciones de botones Preparación Búsqueda de códigos Búsqueda de marcasAjuste del retardo entre dígitos Configuración de favoritosFunción de traspaso de control de vídeo/DVD/DVR Preparación continuaciónProgramación de códigos de dispositivos combinados Consejos para el aprendizaje de códigos Aprendizaje de códigosAprendizaje de comandos Buscador de transmisor de IRInput Eliminación de comandosEl mando no acciona algunas funciones del producto Solución de problemasGarantía limitada de un año El mando no acciona el productoTable des matières Fonctions des touches Fonctions des touches suite Préparation Fonction d’identification de code Entrée de code directe Recherche de code par marqueRecherche de code Réglage du délai entre les chiffres Réglage des favorisRéglage des favoris suite Programmation des codes d’appareils combinés Commande prioritaire de volume/sourdineRéglage Réglage suiteApprentissage des codes suite Apprentissage des codesConseils sur l’apprentissage Détecteur d’émetteur IR Apprentissage des commandes Réinitialisation complète Suppression de commandesSuppression de toutes les commandes ap- prises sous un mode Le voyant clignote après avoir programmé un code La télécommande ne commande pas votre appareilDépannage Garantie limitée de un an