Connecting to TV (cont’d)
Option 1: Using Y Pb Pr jacks
E n g l i s h
Antenna or
Satellite/Cable TV signal
1 2
5
4 3
The Component Video (Y Pb Pr) method of transmitting pictures produces the highest quality as the video signal is split into its Y (brightness), Pb and Pr (blue minus brightness, red minus brightness) components. The signals are transmitted via separate cables. The cables and the associated jacks are mostly colored red, green and blue.
Have the following cables ready:
1)Antenna cable
2)Component video cable (red/green/blue, not supplied)
3)Audio cables (red/white)
1Turn off your TV and remove the antenna cable from your TV (or Satellite Receiver/ Cable Box.) Insert it to the ANTENNA input jack at the back of the DVD recorder.
2Use the supplied antenna cable to connect the DVD recorder’s TV output jack to the antenna input jack at the back of your TV set.
3Use the component video cable to connect the DVD recorder’s COMPONENT VIDEO (OUT 1) jacks to the corresponding component video input jacks (or labeled as YUV or
Y Pb/Cb Pr/Cr) at the back of your TV set.
4Use an audio cable (red/white) to connect the DVD recorder’s
AUDIO L/R (OUT 1) jack to the audio input jack at the back of your TV set (or labeled as AV In or Audio In.)
5Connect the power cable from the DVD recorder’s ~ MAINS to the power supply.
6Press STANDBY-ON 2 on the DVD
recorder to turn it on.
➜ The message 'IS THE TV ON?' appears on the display panel.
7Turn on the TV power. Select the correct Video In channel at the TV (see page 10.)
➜The first installation menu
{Language and Country } will appear on the TV.
11
DVDR610_615_37_Engfinal434 | 11 | 8/16/04, 4:04 PM | 3139 246 14221 |
|