Philips 227E3L Remove Base Stand and Base, Resolution notification, Physical Function Tilt

Page 10

2. Setting up the monitor

Resolution notification

This monitor is designed for optimal performance at its native resolution, 1920 × 1080 @ 60 Hz.When the monitor is powered on at a different resolution, an alert is displayed on screen: Use 1920 × 1080 @ 60 Hz for best results.

Display of the native resolution alert can be switched off from Setup in the OSD (On Screen Display) menu.

Physical Function

Tilt

2.3 Remove Base Stand and Base

Remove the Base Stand

Before you start disassembling the monitor base, please follow the instructions below to avoid any possible damage or injury.

1.Place the monitor face down on a smooth surface, taking care to avoid scratching or damaging the screen.

2. Detach the base stand away from the base column by:

(1) Use your fingers to loosen the screw located at the bottom of the base.

(2) Gently move up-and-down to release the latch that locks the base and pull the base away from the base column.

Image 10

Contents Customer care and warranty Troubleshooting & FAQs Table of Contents ‡ Temperature 0-40C 32-95F Safety precautions and mainte- nanceMaintenance OperationService Notational DescriptionsDisposal of product and packing material Waste Electrical and Electronic EquipmentPackage contents Setting up the monitorInstallation Install base standConnecting to your PC Model 227E3LPH Switch monitor’s power on Model 227E3LH Switch monitor’s power onOperating the monitor OSD Menu Basic and simple instruction on the control keysModel 227E3LPH Physical Function Tilt Resolution notificationRemove Base Stand and Base Remove the Base StandSetting up the monitor Image Optimization SmartImage LitePhilips SmartControl Lite InstallationSmartContrast First launch -WizardStart with Standard pane Adjust menu Color menu First color Calibration Screen SmartImage LiteImage Optimization Exit Close SmartControl Lite Custom settings PowerSensorSetting Default settings Available for model 227E3LPH onlyHow to adjust settings Picture/Display Monitor Panel Type Technical SpecificationsBacklight 30,000hrs Environmental Cabinet Color Black Back, Blue Front Finish Glossy@ 60 Hz analog input Resolution & Preset ModesRecommended Resolution @ 60 Hz digital inputPower Management VesaCongratulations Regulatory InformationLead-free Product This display is designed for both you and the planet EN61000-3-22006 Limits for Harmonic Current Emission Epeat Electronic ProductThis product is in conformity with the following standards GS EK1-20002009 GS mark requirement Reorient or relocate the receiving antenna Declaration of Conformity for Products Marked with FCC LogoRegulatory Infomation Paikka/Ilmankierto Placering/VentilationPlassering/Ventilasjon Regulatory Infomation Pixels and Sub pixels Customer care and warrantyPhilips’ Flat Panel Monitors Pixel Defect Policy Types of Pixel DefectsAdjacent dark subpixels Total bright dot defects of all typesDark subpixel Total black dot defects of all typesCustomer Care & Warranty Topaz-Service Company +38 044 245 73 Russia Bulgaria LAN ServiceLithuania UAB Servicenet BelarusContact Information for Apmea region AL Shahd Computer L.L.CTroubleshooting Make sure the computer is turned onImage appears blurred, indistinct or too dark SmartControl Lite FAQsPower on light is too strong and is disturbing Image appears distorted.Text is fuzzy or blurredGeneral FAQs Q2 What is the recommended refresh rate for LCD monitor?Q6 Is the LCD screen resistant to scratches? Q4 How do I adjust the resolution?Q7 How should I clean the LCD surface? Q10 Are Philips LCD monitors Plug-and- Play?Troubleshooting & FAQs Koninklijke Philips Electronics N.V. All rights reserved