Philips 227E3L Setting up the monitor, Installation, Package contents, Install base stand

Page 6

2. Setting up the monitor

2. Setting up the monitor

2.1 Installation

Package contents

www.philips.com/welcome

Quick

Start

Audio cable (optional)

VGA (optional)

DVI (optional)

Install base stand

1.Place the monitor face down on soft and smooth surface taking care to avoid scratching or damaging the screen.

2.Hold the base stand with both hands and firmly insert the base stand into the base column.

(1)Gently attach the base to the base column until the latch locks the base.

(2)Use your fingers to tighten the screw located at the bottom of the base, and secure the base to the column tightly.

2

1

4

Image 6

Contents Customer care and warranty Troubleshooting & FAQs Table of Contents ‡ Temperature 0-40C 32-95F Safety precautions and mainte- nanceMaintenance OperationService Notational DescriptionsDisposal of product and packing material Waste Electrical and Electronic EquipmentPackage contents Setting up the monitorInstallation Install base standConnecting to your PC Model 227E3LH Switch monitor’s power on Model 227E3LPH Switch monitor’s power onOperating the monitor Basic and simple instruction on the control keys OSD MenuModel 227E3LPH Physical Function Tilt Resolution notificationRemove Base Stand and Base Remove the Base StandSetting up the monitor Image Optimization SmartImage LitePhilips SmartControl Lite InstallationSmartContrast First launch -WizardStart with Standard pane Adjust menu Color menu First color Calibration Screen SmartImage LiteImage Optimization Exit Close SmartControl Lite Custom settings PowerSensorSetting Default settings Available for model 227E3LPH onlyHow to adjust settings Technical Specifications Picture/Display Monitor Panel TypeBacklight 30,000hrs Environmental Cabinet Color Black Back, Blue Front Finish Glossy@ 60 Hz analog input Resolution & Preset ModesRecommended Resolution @ 60 Hz digital inputPower Management VesaCongratulations Regulatory InformationLead-free Product This display is designed for both you and the planet EN61000-3-22006 Limits for Harmonic Current Emission Epeat Electronic ProductThis product is in conformity with the following standards GS EK1-20002009 GS mark requirement Reorient or relocate the receiving antenna Declaration of Conformity for Products Marked with FCC LogoRegulatory Infomation Placering/Ventilation Paikka/IlmankiertoPlassering/Ventilasjon Regulatory Infomation Pixels and Sub pixels Customer care and warrantyPhilips’ Flat Panel Monitors Pixel Defect Policy Types of Pixel DefectsAdjacent dark subpixels Total bright dot defects of all typesDark subpixel Total black dot defects of all typesCustomer Care & Warranty Topaz-Service Company +38 044 245 73 Russia Bulgaria LAN ServiceLithuania UAB Servicenet BelarusContact Information for Apmea region AL Shahd Computer L.L.CTroubleshooting Make sure the computer is turned onImage appears blurred, indistinct or too dark SmartControl Lite FAQsPower on light is too strong and is disturbing Image appears distorted.Text is fuzzy or blurredGeneral FAQs Q2 What is the recommended refresh rate for LCD monitor?Q6 Is the LCD screen resistant to scratches? Q4 How do I adjust the resolution?Q7 How should I clean the LCD surface? Q10 Are Philips LCD monitors Plug-and- Play?Troubleshooting & FAQs Koninklijke Philips Electronics N.V. All rights reserved