Philips 26HW9100D, 30HW9100D user manual Basic Television Connection

Page 4

L05 User’s Manual

091105.1833

Basic Television Connection

Antenna Connection

• Connect the antenna or RF cable signal to the 75-ohm RF ‘F’ connector socket located on the TV’s rear jack panel.

Mains Connection

• Verify that the mains voltage and frequency are correct. Please refer to the product labeling and documentation. Note: The power button on the front panel does not disconnect the television from the AC mains; it toggles the TV’s power mode between on and standby. To completely remove AC mains power, you must unplug the AC mains plug.

Switching on the Set

• Press the power button on the TV’s front panel or on the remote control to switch on the set.

Note 1: If the TV is in commercial mode, it might not respond to the front panel or the remote control, depending upon the TV’s mode and setup configuration. Please refer to the section TV Installation and TV Setup Menu in this documentation for more information.

Note 2: See Mains Connection, above.

Image 4

Contents 26HW9100D/30HW9100D User’s Manual Safety Information Before Calling Service Symptom Possible Corrective ActionBasic Television Connection Use And Care of Remote Control Rear Jack Panel ConnectionsRemote Controls Guest Remote Control Keys DVD StopConsumer vs. Commercial Mode Accessing TV Setup MenusPage TV Setup Main Menu TV Setup Menu and Sub-Menus Installing AV Inputs ∙ Label∙ Video Blank ∙ Audio MuteFactory CH Reset Cursor Right will reset the channels programmed in memory∙ Major Channel ∙ Minor ChannelUSE Channel Table NO/YES Digital OSDNO/YESEnter Digital Menu Cursor Right will bring up the Consumer Digital Menu belowDefault Format BrightnessColor ContrastUsing the different formats Noise Reductionno / YESSound Mode Mono / Stereo Volume BARAvloff / on BalanceMAX Volume Switch on Volumestandard / 0Power Onstandard / Forced /RESTORED Channel Displaynone / Number / Label / ALLESP AUDIO/VIDEO Muteoff / Black / BlueAUDIO/VIDEO OUT Mute Monitor OUT Rfno / YESChannel Guide No / YES / Power on ∙ DISPLAYNO/YES∙ Line 1/LINE ∙ ClearCH A/V Switchno / YES Reminderno / YESDigit Entryno / YES Most recently selected channel / inputSource Menu Itemno / YES Save Ccno / YESHdmi Audio Selectionhdmi / AV1 / AV2 / AV Chip Setup SleeptimerChip Menu Itemno / YES Save V-CHIPNO / YESSleeptimer Countdown In Progress example Security Standard / High26HW9100D Dimensions 30HW9100D Dimensions