Philips FW-C380 General Information, Environmental Information, Energy Star, Supplied Accessories

Page 7

General Information

The type plate (which contains the serial number) is located at the rear of the player.

Recording is permissible if copyright or other rights of third parties are not infringed.

This product complies with the radio interference requirements of the European Community.

Environmental Information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Energy Star

As an ENERGY STARR Partner; Philips has determined that this product meets the ENERGY STARR guidelines for energy efficiency.

Supplied Accessories

Remote control

AM loop antenna

FM wire antenna

AC power cord

Safety Information

Before operating the player, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your player is identical with the voltage of your local power supply. If not, please consult your dealer.The typeplate is located at the rear of your player.

When the player is switched on, do not move it around.

Place the player on a solid base (e.g. a cabinet).

Place the player in a location with adequate ventilation to prevent internal heat build-up in your player. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from the each side.

Do not expose the player to excessive moisture, rain, sand or heat sources.

Under no circumstances should you repair the player yourself, as this will invalidate the warranty!

If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the player. Should this occur, the CD player will not operate normally. Leave the power on for about one hour with no disc in the player until normal playback is possible.

Electrostatic discharge may cause unexpected problems. See whether these problems disappear if you unplug the AC power cord and plug it in again after a few seconds.

To disconnect the player from the power supply completely, remove the AC power plug from the wall socket.

English

 

 

7

pg 01-30/C380/22-Eng

7

12/7/00, 3:42 PM 3139 115 20641

Image 7
Contents FW-C380 Copyright in the U.K How to connect a plugImportant notes for users in the U.K Mains plugTape 3139 115 179 107131 155Contents Environmental Information Supplied AccessoriesSafety Information General InformationRear Connections PreparationsPreparation Inserting batteries into the Remote ControlThey should be disposed off properly Tape / Tape 1 Controls on the player and remote controlSTANDBY-ON y CD / CDThen select the desired function É, í, ë, etc Search à á Tuning à áPrev í / Next ëPRESET 4 ControlsOperating the System Preparation proceduresPlug and Play Switching the system on Demonstration modeSwitching the system to standby mode Sound Control DIM modeVolume Control Selecting the Source¶ Press Incredible Surround to switch on Press to select the VEC feature VEC led lights upTo switch on Optimal Sound Mix ¶ Press Optimal Sound MIX Discs for playback Compact DiscDisc Direct Play Searching for a particular passage during playback Playing a DiscDisc Change Selecting a desired trackPlaying the programme Erasing the programme when playback is stoppedShuffle only on remote control Reviewing the programmeTuner Tuning to radio stationsStoring Preset Stations Select preset 10 before starting automaticReceiving RDS Radio Station Ç Tuning to Preset Radio StationsManual programming To start News function Setting the time with RDS clock Press ClocktimerTo cancel News function RDS ClockAuto Replay This feature is available during tape playback onlyTape Loading a tapeAux When playback is stoppedDuring playback Press Ç to stop recording One Touch RecordingFor recording, use only tape of IEC type I normal tape Load a blank tape in tape deckDigital Recording via Digital Out RecordingCD Synchro Start Recording Recording from other sourcesFrom the minimum level to the most Clock/Timer¶ The volume of the timer will increase Recently selected volume levelWhile Sleep mode is activated To switch off the TimerPress and hold Clocktimer for more than 2 seconds To start the Timer again for the sameSubject to modification SpecificationsTroubleshooting MaintenanceSymptom Remedy Tape deck door cannot open System does not react when anyRecording or playback cannot be Level