Philips BDS4223V user manual System Pass Code, Setting System Pass code

User Manual BDS4223V

ENTER PASS CODE

INCORRECT!!

7.6SYSTEM PASS CODE

Setting System Pass code

The system pass code setting is used in conjunction with V-Chip (Parental Guide) and Channel Lock functions. The same security passcode is used for both functionality. By default, this monitor is shipped with the security pass code set at 0000.

1Press the MENU on the monitor panel or remote control.

2Use the SEL or SEL key to select the SETUP option from the menu.

3Press the ADJ key to confirm the selection.

=> Various options are available in the SETUP menu.

4Use the SEL or SEL key to select the PASS CODE option.

5Press the ADJ key to confirm selection. => The ENTER PASS CODE window appears.

6Use the number keys on the remote control to enter the currently used pass code. As each numeric digit is entered, a small "X" fills each slot.

●If the code has not been set before, please use the default "0000" code.

●If the code entered is incorrect, an "Error" status is displayed. Simply enter the pass code again.

Notes:

●When entering the 4-digit pass code, please enter the digits slowly. The monitor will display "X" in each of the number slots as it receives the pass code.

●If the wrong passcode is entered three times, the monitor will go back to the SETUP menu. Repeat the above procedure to reset your pass code.

7When the currently used passcode is entered correctly, the monitor will prompt to enter of a new passcode. Enter the four digit passcode using the numeric keypad on the remote control.

8Re-enter the new passcode one more time to confirm.

Note:

Please contact authorized customer service center if you did forget the pass code.

46