Hooking Up the TV/VCR (cont’d) 7
C.
Hooking Up Your TV/VCR With an Indoor Antenna
To install a rod antenna (supplied), push the stem of the antenna into the antenna hole on the back of the TV/VCR. Connect the anten- na wire to the ANT(enna) Jack on the back of the TV/VCR as shown. Extend the antenna and adjust its length, direction, and angle for the clearest picture.
Rod Antenna (supplied)
DC 13.2V
AC 120V
ANT.
ANT
2
Connect the AC cord to the AC 120V jack on the back of the TV/VCR. Plug the AC cord into an AC power outlet.
3
Before you turn on the TV/VCR, go to page nine.
Helpful Hint
• Before connecting an antenna or cable signal to the ANT(enna) Jack, make sure the pin is not bent. If the pin is bent, straighten it as illustrated, then connect the antenna or cable signal to the ANT(enna) Jack.
Bent pin
Crooked Pin
Cable | Plug |