Philips CCA092AT Putting Batteries in the Remote Control, Erasure Prevention, TV/VCR Maintenance

Page 5

Putting Batteries in the Remote Control

1

Remove the battery compartment lid on the bottom of the remote control by sliding the lid in the direction of the arrow.

2

Place two AA batteries inside the battery compartment with their + and – ends aligned as indicated.

3

Replace the battery compartment lid.

Erasure Prevention

Video cassette tapes have record tabs to ensure that recordings are not erased accidentally.

Before Using the TV/VCR 5

1

2

3

1

To prevent accidental erasure, break off the tab with a screwdriver.

2

To record again, cover the hole with cellophane tape.

Using the Remote Control

●Point the remote control at the TV/VCR’s remote sensor.

●Do not put objects between the remote control and the TV/VCR.

1

2

TV/VCR Maintenance

●In this TV/VCR, use only tapes with the mark.

●Make sure any light adhesive stick-on notes are removed from the video cassette tape before putting the tape in the TV/VCR. Removable labels like these can jam the TV/VCR.

●Periodic maintenance is required to maintain your TV/VCR’s excellent performance. This TV/VCR has an automatic head cleaning system. However, the video heads will eventually require cleaning or replacement. Only an authorized service cen- ter should perform this service.

Helpful Hints

•The remote control and its batteries are supplied.

•Do not mix alkaline and man- ganese batteries.

•Do not mix old and new batteries.

Image 5

Contents CCA092AT For Customer Use Dear Philips Magnavox product ownerSafety Precautions FeaturesIntroduction Philips Consumer Electronics Company recommends that youTable of Contents Using the Remote Control Putting Batteries in the Remote ControlTV/VCR Maintenance Erasure PreventionHooking Up the TV/VCR Hook up your TV/VCR using one of the connections shownStraight Pin Rod Antenna suppliedCrooked Pin Hooking Up the TV/VCR cont’d Car battery cordMobile Connections To Cigarette LighterTurning On the TV/VCR You cannot set up channels if you are using a Cable BoxPress the Menu button Language SelectionAutomatic Channel Setup Press the PLAY/ o button or the STOP/ p button to select Adding/Deleting ChannelsCable Box users must set the clock manually Manual Clock SettingInstructions continue on Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’dWait for the TV/VCR to find the time Manual PBS Channel Selection Use the Number buttons to select your PBS station Press the PLAY/ button or the STOP/ button toSelect SET PBS CH. MANUAL. Then, press the F.FWD/B Daylight-Savings Time Time Zone Primary SetupFront Panel ANTenna Jack Rear PanelDC 13.2V Jack AC 120V JackRemote Control Buttons Remote Control Buttons cont’d If you select Status OFF If you select Status ON, then select Counter only OFFIf you select Status ON, then select Counter only on Adjusting the Picture Controls Decrease Increase Adjusting the Picture Controls cont’dMore brilliant SofterPlaying Recording options are on pages RecordingOne-Touch Recording Different brands of equipment may operate differently Rerecording Tape DuplicationDaily Timer RecordingTimer Recording cont’d Timer Recording cont’d With the TV/VCR on, press the Menu button Checking or Clearing Timer RecordingsPress the PLAY/ button or the STOP/ button to select VCR PROGRAM, then press the F.FWD/B buttonDefeat Recording Repeat Play Insert a tape in the TV/VCR Press the Menu button B Repeat PlayPress the STATUS/EXIT button to remove the display. a Repeat Play cont’dPress the STATUS/EXIT button. The real-time counter will Real-Time Counter MemoryForward and Reverse Searching SP/LP/SLP Playback OptionsSuper High Speed Searching LP/SLP Viewing a Still PictureGround Blue BackgroundSleep Timer Volume Bar Reminder Automatic Operation Features Glossary SpecificationsHelpful Hints Helpful Hints cont’d TV/VCR Combination Limited WarrantyControls Remote 23-24 Tv/vcr IndexSupplied Accessories