Philips CCB 194AT, CCB 134AT owner manual Timer Recording cont’d

Page 35

Timer Recording (cont’d) 35

4

Use the Number buttons (1-8) to select a position in which to store the timer recording. Flashing numbers indi- cate an open position (one in which a timer recording has not been stored yet).

NOTE: If you select a number that already has been used to store a timer recording, PREVIOUSLY SET PROGRAM will appear on the screen for a few seconds. Then information about the program in that position will appear on the screen. If this happens, press the STATUS/EXIT but- ton. Then use the Number buttons to select another position.

5

Use the Number buttons to enter the channel of the TV program you want to record.

●If you are recording from line input, press 0, 0. A/V IN will appear on the screen.

●If you are recording using a Cable Box, enter the Cable Box output channel (03 or 04). Be sure to select the channel of the TV program at the Cable Box and leave the Cable Box on for the timer recording.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL – – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

6

Press two Number buttons for the hour(s) you want the recording to begin. Press two Number buttons for the minute(s) you want the recording to begin. Press 1 for AM or 2 for PM. For example, for 9:30 PM, press 09, 30, 2.

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

7

Follow the instructions in step 6 to set the recording’s stop time. (AM or PM will be set automatically.)

ONE TIME PROGRAM

PROGRAM 1

CHANNEL	10
TIME ON	09:30 PM
TIME OFF	– – : – –

TO CORRECT PRESS CLEAR

TO END PRESS EXIT

Instructions continue on page 36.

4-7

POWER		EJECT
SLEEP/WAKE UP	SPEED	MEMORY
REC/OTR		PAUSE/STILL

	PLAY
REW		F.FWD
	STOP
MENU	STATUS/EXIT	CLEAR

1	2	3
4	5	6	CH.
4	5	6
7	8	9
FM	0	SURF	VOL.
			VOL.
CABLE/DBS	COMBI
		VCR PLUS+
VAR.SLOW		/ENTER	MUTE
TRACKING		F.ADV	SLOW
SMART		SKIP INDEX
PICTURE	SOUND	SEARCH SEARCH

Helpful Hints

•If the numbers entered do not match the TV/VCR’s clock or calendar, the entry will be rejected and a question mark will appear on the screen.

•To make corrections while you are programming a timer recording, press the CLEAR button until the cursor is flashing on the item you want to change. Then enter the correct infor-

mation.

Image 35

Contents CCB134AT CCB194AT Model No Serial No Dear Philips product ownerFor Customer Use This bolt of lightning indi- cates uninsulated materialDeclaration of Conformity FeaturesSafety Precautions IntroductionTable of Contents Erasure Prevention Putting Batteries in the Remote ControlUsing the Remote Control TV/VCR MaintenanceRod Antenna Hook up your TV/VCR using one of the connections shownHooking Up the TV/VCR Crooked Pin Straight Pin Hooking Up the TV/VCR cont’dAUDIO/VIDEO Jacks on front Bent pinPress the Menu button. The screen shown below will appear Press the Combi button, then press the Power buttonTurning On the TV/VCR Press the Combi button, then press the Menu button Language SelectionWait for the TV/VCR to set up channels Automatic Channel SetupProgramming of the last channel you selected will appear Adding/Deleting ChannelsPress the PLAY/o button or the STOP/p button to select Repeat steps 3-4 to add or delete other channelsCable Box users must set the clock manually Setting the ClockManual Clock Setting Setting the Clock cont’d Automatic PBS Channel Selection Setting the Clock cont’dNOW Searching flashes on the TV/VCR screen Wait for the TV/VCR to findTime Manual PBS Channel Selection Wait for the TV/VCR to find the time Use the Number buttons to select your PBS stationTime Daylight Savings Time Daylight-Savings TimePress the PLAY/ button or the STOP/ button to select PRIM. SETUP. Then, press the F.FWD/B buttonTime Zone Within 30 seconds, press the CABLE/DBS button Setting the Remote to Operate a Cable Box/DBSPress the Mute button Setting the Remote to Operate a Cable Box/DBS cont’d Cassette Compartment Earphone Jack Volume o/ p ButtonsWireless Remote Sensor Power ButtonConnect your antenna or cable here AC Power CordRear Panel ANTenna JackRemote Control Buttons REWind/ Button VOLume m/ n ButtonPAUSE/STILL Button Memory ButtonPress the REWind/ button or the F.FWD/B button to Adjusting the Picture ControlsAdjust the picture control. Refer to the chart on When you finish, press the STATUS/EXIT buttonDecreased brightness Decrease IncreaseIf you select Status OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only OFF If you select Status ON, then select Counter only onInsert a tape in the TV/VCR PlayingPress the RECord/OTR button once to start recording Power button to turn on the TV/VCR, if necessaryRecording OTR One-Touch RecordingDifferent brands of equipment may operate differently Rerecording Tape DuplicationFollow the steps below to prevent accidental recording Defeat RecordingDaily Timer RecordingLowed by the SET Clock menu Timer Recording cont’d FM 0 Surf VOL Timer Recording cont’dChecking or Clearing Timer Recordings Station Setting Up the VCR Plus+ Programming SystemTV Channels Setting Up the VCR Plus+ Programming System cont’d You have completed the steps on pages Timer Recording With the VCR Plus+ Programming SystemTimer Recording With the VCR Plus+ Programming System cont’d Appear on the screen Real-Time Counter MemoryRepeat Play ON-SCREEN Mode Defeat Recording OFFInsert a tape in the TV/VCR B Repeat PlayFlashing a will become a flashing B Repeat Play cont’dViewing a Still Picture Playback OptionsForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPBlue Background To block ratings, follow the steps below SmartLockExample Specific Sub-ratings SmartLock cont’dRatings are defined on After you enter the code, the Smartlock menu will appear To change the access code, follow these stepsTV-Y7 To check the SmartLock settings, follow these stepsPress the Combi button, then press the SLEEP/WAKE UP button Sleep TimerTimer during a recording Wake Up Timer Screen Closed CaptionExample MenuHalf-screen text Closed Caption cont’dStandard Closed Captions Smart Sound Volume Bar/Smart SoundVolume Bar Volume will stay at the same levelAutomatic Operation Features Follow the steps below to listen to FM radio stations SmartPicture/FM RadioSmartPicture FM RadioPress the Mute button, then press the PAUSE/STILL button If another remote control beepsPress the Combi button, then press the Menu button ReminderIndex Search Specifications Glossary Helpful Hints Helpful Hints cont’d Model # Serial # Limited WarrantyPlease contact Philips at French Speaking English Speaking Index Supplied Accessories