Philips SVA102 owner manual Hookups With a Stereo TV

Page 10

10 Hookups With a Stereo TV

			antenna or
			1 ANT(enna)cable to
		ANT	IN Jack
		IN
AUDIO
OUT	IN	OUT
		OUT
VIDEO		CH3 CH4
VIDEO
VIDEO (yellow) and		2
AUDIO (white) OUT Jacks		2	Video Cable
AUDIO (white) OUT Jacks

3 Audio Cable

●Audio and Video cables are not supplied.

1

Connect the antenna or cable to the ANT(enna) IN Jack on the back of the VCR.

2

Connect a video cable to the yellow VIDEO OUT Jack on the back of the VCR. Then, connect the other end of the video cable to the VIDEO IN Jack on your TV.

3

Connect an audio cable to the white AUDIO OUT Jack on the back of the VCR. Then, connect the other end of the audio cable to the AUDIO IN Jack on your TV.

(If your TV has Right and Left AUDIO IN Jacks, you must use a “Y” splitter audio cable as illustrated to deliver audio to the TV’s right and left channels.)

4

Turn on your TV, making sure it is in Line Input mode. Please refer to your TV owner’s manual for details.

Audio and Video IN Jacks on TV

Helpful Hint

•This hookup will not give you stereo sound. To get stereo sound, use the connections on pages six-seven and select the channel to be viewed at the TV (with the VCR turned off).

Image 10

Contents Video Cassette Recorder Warranty Verification For Customer UseSafety Precautions FeaturesIntroduction Table of Contents VCR maintenance Putting Batteries in the Remote ControlUsing the Remote Control Replace the battery compartment lidHookups Without a Cable Box/Direct Broadcast System Disconnect the antenna or cable from your TVHookups Without a Cable Box/Direct Broadcast System cont’d Plug in the TV and the VCRConnections Hookups With a Cable Box/Direct Broadcast SystemRecording/Viewing Any Channel Recording One Channel/Watching Another Select the channel you want to watch at the Cable Box/DBSHookups With a Stereo TV Turning on Your VCR 2Turn on the TVAutomatic Channel Setup Automatic Channel Setup cont’d Adding/Deleting ChannelsSetting the Clock Follow the steps below to set your VCR’s clock. Make sureSetting the Clock cont’d 96-7Press the Counter RESET/EXIT button Language SelectionPress the Display button once Clock mode OFF mode Press the Display button once Count modeOn-Screen Status Displays Number Buttons Remote Control ButtonsPower Button Rental Selector ButtonAuto Repeat Button Counter RESET/EXIT ButtonEject Button CLOCK/COUNTER ButtonVCR Display Panel Front Panel Audio OUT Jack AC Power CordRear Panel Video OUT JackPlaying Read and follow the steps below to play a tapeRecording 1Turn on the TV Insert a tapeStarting an OTR Stopping an OTRTimer Recording Program Number → Once Daily WeeklyTimer Recording cont’d Repeat the procedure in to set the recording’s end time4Press the Counter RESET/EXIT button to exit Cancelling a Timer Recording Correcting a Timer RecordingPress the Play button or the Stop button repeatedly to Auto ReturnSelect Auto Return Put the VCR in VCR position. The VCR/TV light will appear Press the VCR/TV button on the VCR remote control toTo return to the channel being recorded, use the TV To stop recording, press the Stop buttonRerecording Tape Duplication RF coaxial cableRepeat Play Super High Speed Searching LP/SLP Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Viewing a Still PictureRental Play Real-Time Counter Memory Press the Play button to watch the tapeAutomatic Playback Features Helpful Hints Helpful Hints cont’d Glossary Cable Box/DBS Output Channel Channel 3 orSpecifications Limited Warranty Video Cassette RecorderIndex Supplied Accessories