![](/images/new-backgrounds/1129107/12910747x1.webp)
Chapter 3 Installing the Chassis
Removing the Power Supply Module
Figure 3-11 Rear View of Power Supply Module
Fan module
Fuse |
|
|
holders | Fuse 1 | Fuse 2 |
| Power 1 | Power 2 |
DC Power connectors
Voltage: | 115/230 V 50/60 Hz | |||
Max. Current: | 2.5 A | |||
Power Consumption: | max. 100W | |||
Fuse: |
|
|
| 2x T2.5A / 250V |
|
|
|
For continued protection against risk of fire replace only with same type and ratings of fuse.
For proper selection of power supply cord refer to instruction manual.
|
| Always remove both |
Made in Germany | ! | power cords when dis- |
March 1998 | connecting from power | |
| source 1. |
32268
All PSMs are
Step 1 Remove the power cord associated with the failed power supply and loosen the four panel screws.
Step 2 Pull out the malfunctioning module.
Step 3 Slide in the spare module.
Step 4 Check that the green LED is on.
Step 5 Reconnect the power cord.
Step 6 Tighten the four panel screws.
| Cisco Metro 1500 Series Hardware Installation Guide |