ADJUSTMENT INSTRUCTIONS
STEP 5: Hold the FAN(17) so that the FRONT SPROCKET is on your left side as shown.
STEP 6: Loosen NUTS "A" and "B" until at least 1/2" of AXLE is showing between NUT "A" and the
BEARING.
STEP 7: Tighten NUT "C" completely until it bottoms out on the last AXLE thread. Then tighten NUT "D".
STEP 8: Tighten NUT "A" completely against BEARING, then back off 1/4 turn or until the AXLE has a very small amount of play side to side.
STEP 9: Hold NUT "A" and tighten NUT "B" completely against the SPEED PICKUP and NUT "A". NOTE: The FAN should be able to spin freely on the AXLE after completion of this step.
FAN | NUT A | |
BEARING | SPACER | |
WASHER | ||
| ||
WASHER | NUT B |
AXLE | SPEED PICKUP | |
| ||
NUT D |
| |
NUT C | WASHER | |
FRONT | ||
BEARING | ||
SPROCKET |
STEP 10: Reverse STEPS 1 through 4 to reinstall the FAN(17),
WIRE CAGES(31, 32), CHAIN(16), and CHAIN
GUARDS(33, 34).
NOTE: DO NOT tighten ACORN NUTS(3/8")(70) and
NYLOCK NUTS(M6)(67) until STEP 11.
STEP 11: The CHAIN must be adjusted as follows:
a. Make sure the CHAIN(16) is on both the FRONT and REAR SPROCKET.
b. Tighten NYLOCK NUTS(M6)(67) on EYE BOLTS(22) until all slack is removed from CHAIN(16) and CENTER of ACORN NUTS(3/8")
(70)are the same distance from TENSION BRACKET(23) on both sides of BIKE.
c.Tighten ACORN NUTS(3/8")(70).
12