ASSEMBLY INSTRUCTIONS
IMPORTANT STUDY THE ABOVE ILLUSTRATION AND READ ALL OF STEP 8 "a" through "g"
BEFORE ATTACHING PEDALS AND CONNECTING LINKAGES.
STEP 8
NOTE: The RIGHT PEDAL(83) has R marked on the bottom side of the pedal. The LEFT PEDAL(82) has L marked on the bottom side of the pedal. Both PEDALS(82, 83) have RIGHTHAND THREADS. Tighten both PEDALS(82, 83) by turning clockwise.
a.Push PEDAL BUSHINGS(37), with SHOULDER facing outside, into LINKAGE CONNECTORS(39).
b.Insert PEDAL SHAFTS of PEDALS(82, 83) through SHOULDER side of PEDAL BUSHINGS(37).
c.Slide SPACERS(84) onto PEDAL SHAFTS.
WARNING: SPACER(84) must be between PEDAL BUSHING(37) and CRANK(9) so that there will be enough clearance between LINKAGE(8) and CRANK(9).
d.Thread PEDAL SHAFTS of PEDALS(82, 83) into CRANK(9) and tighten.
e.Hold PEDAL SHAFTS and thread THIN NUTS(1/2")(41) onto PEDAL SHAFTS.
f.Tighten PEDAL SHAFTS and THIN NUTS(1/2")(41) until THIN NUTS(1/2")(41) are tight against CRANK(9).
g.Connect the LINKAGES(8) to the LINKAGE CONNECTORS(39) with the LOCKING PINS(40).
STEP 9
Open the MONITOR(53) to Install two AA batteries. Run the SPEED PICKUP WIRE(24) through the hole on the Back Cover of the MONITOR(53) and plug into the MONITOR(53). Insert MONITOR(53) into the Back Cover. Attach the MONITOR(53) to the BRACKET(52) on the MAIN FRAME(1).
8